Toyota Tundra. Manual — part 159
TESTER CONNECTION SPECIFIED CONDITION
for Built-in Type Amplifier System
TESTER CONNECTION SPECIFIED CONDITION
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
Tester Connection
Switch Condition Specified Condition
K9-4 (SPD) - J28-35 (+S)
Ignition switch OFF
Below 1 ohms
K9-4 (SPD) - Body ground
10 kohms or higher
Tester Connection
Switch Condition Specified Condition
K3-3 (SPD) - J28-35 (+S)
Ignition switch OFF
Below 1 ohms
K3-3 (SPD) - Body ground
10 kohms or higher
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Fig. 60: Checking Harness And Connector (Combination Meter - Radio Receiver)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
OK: REPLACE COMBINATION METER (See REMOVAL )
STEERING PAD SWITCH CIRCUIT
DESCRIPTION
This circuit sends an operation signal from the steering pad switch to the radio receiver. If there is an open in
the circuit, the audio system cannot be operated using the steering pad switch. If there is a short in the circuit,
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
the same condition as when the switch is continuously depressed occurs. Therefore, the radio receiver cannot be
operated using the steering pad switch, and also the radio receiver itself cannot function.
WIRING DIAGRAM
Fig. 61: Steering Pad Switch - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. INSPECT RADIO RECEIVER
a. Disconnect the K3 receiver connector.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITION
CAUTION: The vehicle is equipped with an SRS (Supplemental Restraint System)
which includes components such as airbags. Before servicing (including
removal or installation of parts), be sure to read the precautionary notice
for the SRS (see PRECAUTION ).
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
NG: Go to step 2
Fig. 62: Identifying K3 Receiver Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE (see PROBLEM SYMPTOMS TABLE )
2. INSPECT STEERING PAD SWITCH ASSEMBLY
a. Disconnect the z3 switch connector.
b. Measure the resistance according to the values in the table below.
Tester Connection
Switch Condition
Specified Condition
K3-7(SW1) - K3-6 (SWG)
No switch is pushed 100 kohms or higher
Seek+ switch: push
Below 1 ohms
Seek- switch: push
329 ohms
Volume* switch: push
1000 ohms
Volume- switch: push
3100 ohms
K3-8 (SW2) - K3-6 (SWG)
No switch is pushed 100 kohms or higher
MODE switch: push
Below 1 ohms
On Hook switch: push
329 ohms
Off Hook switch: push
1000 ohms
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст