Toyota Tundra. Manual — part 1142
O2S (A/FS)
Heater
Monitor
O2S (A/FS) heater
monitor:
Not Avl or Avail
-
-
O2S (A/FS)
Heater
Monitor
O2S (A/FS) heater
monitor:
Compl or Incmpl
-
-
O2S (A/FS)
Heater
Monitor
O2S (A/FS)
monitor:
Not Avl or Avail
-
-
O2S (A/FS)
Monitor
O2S (A/FS)
monitor:
Compl or Incmpl
-
-
2nd Air
Monitor
2nd air monitor:
Not Avl or Avail
-
-
2nd Air
Monitor
2nd air monitor:
Compl or Incmpl
-
-
EVAP
Monitor
EVAP monitor:
Not Avl or Avail
-
-
EVAP
Monitor
EVAP monitor:
Compl or Incmpl
-
-
Catalyst
Monitor
Catalyst monitor:
Not Avl or Avail
-
-
Catalyst
Monitor
Catalyst monitor:
Compl or Incmpl
-
-
Component
Monitor ENA
Comprehensive
component
monitor:
Unable or Enable
-
-
Component
Monitor
CMPL
Comprehensive
component
monitor:
Compl or Incmpl
-
-
Fuel System
Monitor ENA
Fuel system
monitor:
Unable or Enable
-
-
Fuel System
Monitor
CMPL
Fuel system
monitor:
Compl or Incmpl
-
-
Misfire
Monitor ENA
Misfire monitor:
Unable or Enable
-
-
Misfire
Monitor
CMPL
Misfire monitor:
Compl or Incmpl
-
-
EGR Monitor
ENA
EGR monitor:
Unable or Enable
-
-
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
EGR Monitor
CMPL
EGR monitor:
Compl or Incmpl
-
-
Heater
Monitor ENA
O2S (A/FS) heater
monitor:
Unable or Enable
-
-
Heater
Monitor
CMPL
O2S (A/FS) heater
monitor:
Compl or Incmpl
-
-
O2S (A/FS)
Monitor ENA
O2S (A/FS)
monitor:
Unable or Enable
-
-
O2S (A/FS)
Monitor
CMPL
O2S (A/FS)
monitor:
Compl or Incmpl
-
-
A/C Monitor
ENA
A/C monitor:
Unable or Enable
-
-
A/C Monitor
CMPL
A/C monitor:
Compl or Incmpl
-
-
2nd Air
Monitor ENA
2nd air monitor:
Unable or Enable
-
-
2nd Air
Monitor
CMPL
2nd air monitor:
Compl or Incmpl
-
-
EVAP
Monitor ENA
EVAP monitor:
Unable or Enable
-
-
EVAP
Monitor
CMPL
EVAP monitor:
Compl or Incmpl
-
-
Heated Cat
Monitor ENA
Heated catalyst
monitor:
Unable or Enable
-
-
Heated Cat
Monitor
CMPL
Heated catalyst
monitor:
Compl or Incmpl
-
-
Catalyst
Monitor ENA
Catalyst monitor:
Unable or Enable
-
-
Catalyst
Monitor
CMPL
Catalyst monitor:
Compl or Incmpl
-
-
MIL
MIL status:
ON or OFF
ON: MIL ON
-
Model Code
Model code
-
Identifying model code: GSK5#
Engine Type
Engine type
-
Identifying engine type: 1GRFE
Cylinder
Number
Cylinder number:
Min.: 0, Max.: 255
-
Identifying cylinder number: 6
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
2. ACTIVE TEST
HINT:
Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to
be operated without removing any parts. This non-intrusive functional inspection can be very useful
because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active
Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed
while performing Active Tests.
a. Connect the Techstream to the DLC3.
b. Turn the ignition switch ON.
c. Turn the Techstream ON.
d. Enter the following menus: Powertrain/Engine and ECT/Active Test.
e. According to the display on Techstream, perform the "Active Test".
ACTIVE TEST CHART
Transmission
Type
Transmission type
-
Identifying transmission type: 5AT
Destination
Destination
-
Identifying destination: A (America)
Model Year
Model year:
Min.: 1900, Max.:
2155
-
Identifying model year: 200#
System
Identification
System
identification
-
Identifying engine system: GASOLINE
(gasoline engine)
HINT:
*3: If no idling conditions are specified, the shift lever should be in the N or P position, and
the A/C switch and all accessory switches should be OFF.
*4: Data List values are only displayed when performing the following Active Tests:
Control the VVT Linear (Bank 1), Control the VVT Linear (Bank 2), Control the VVT
Exhaust Linear (Bank 1) and Control the VVT Exhaust Linear (Bank 2). For other Active
Tests, the Data List value will be 0.
Tester Display
Test Part
Control
Range
Diagnostic Note
Control the
Injection Volume
Change injection
volume
-12.5 to 24.8%
All injectors tested at the same
time
Perform test at less than 3000
RPM
Injection volume can be changed
in 1% graduations within control
range
Perform test at less than 3000
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Control the
Injection Volume
for A/F Sensor
Change injection
volume
Lower by
12.5% or
increase by
24.8%
RPM
Control the Injection Volume for
A/F Sensor enables checking and
graphing of A/F (Air Fuel Ratio)
sensor and Heated Oxygen
(HO2) sensor voltage outputs
To conduct test, enter the
following menus: Active
Test/Control the Injection
Volume for A/F Sensor/Data
List/A/F Control System/AFS B1
S1 and O2S B1 S2
Activate the VSV
for Secondary Air
Control
Activate the
Secondary Air
System
ON/OFF
Do not perform test for 5 seconds
or more
After test, do not perform test
again for 30 seconds
Activate the VSV
for Intake Control
Activate VSV for
intake control
ON/OFF
-
Activate the VSV
for EVAP Control
Activate purge VSV
control
ON/OFF
-
Control the A/C
Cut Signal
Control the A/C cut
signal
ON/OFF
-
Control the Fuel
Pump Speed
Activate fuel pump
(C/OPN Relay)
ON/OFF
Test possible when following
conditions met:
Ignition switch ON
Engine is stopped
Connect the TC
and TE1
Turn on and off TC
and CG (TE1)
connection
ON/OFF
ON: TC and TE1 connected
OFF: TC and TE1 disconnected
Control the Idle
Fuel Cut Prohibit
Prohibit idling fuel
cut control
ON/OFF
-
Prohibit the
Catalyst OT
Misfire prevent
F/C
Prohibit catalyst
overheat malfunction
prevention fuel cut
operation during
misfire
ON: Fuel cut is
prohibited
Confirm that the Vehicle is Stopped
and Engine Speed is 3000 RPM or less.
Active the Starter
Relay
Activate starter relay ON/OFF
-
Active the ACC
Cut Relay
Activate ACC cut
relay
ON/OFF
Test possible when following
conditions met:
Ignition switch ON
Engine is stopped
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст