Toyota Tundra. Manual — part 1575
TYPICAL ENABLING CONDITIONS - P0451
P0452 and P0453:
TYPICAL ENABLING CONDITIONS - P0452 AND P0453
TYPICAL MALFUNCTION THRESHOLDS
P0451: Canister pressure sensor noise
TYPICAL MALFUNCTION THRESHOLDS - P0451
P0451: Canister pressure sensor fixed/flat
TYPICAL MALFUNCTION THRESHOLDS - P0451
P0452: Canister pressure sensor low voltage
TYPICAL MALFUNCTION THRESHOLDS - P0452
P0453: Canister pressure sensor high voltage
TYPICAL MALFUNCTION THRESHOLDS - P0453
WIRING DIAGRAM
Monitor runs whenever following DTCs not
present
P0452, P0453 (EVAP System)
Battery voltage
10.5 V or more
Intake air temperature
4.4 to 35°C (40 to 95°F)
Atmospheric pressure (absolute pressure)
Less than 70 kPa-a (525 mmHg-a) or 110 kPa-a (825
mmHg-a) or more
Time after key off
5 or 7 or 9.5 hours
Monitor runs whenever following DTCs not present
None
Either of following conditions met
(a) or (b)
(a) Ignition switch
ON
(b) Soak timer
ON
Frequency that EVAP pressure change 0.3 kPa-g (2.25 mmHg-g) or more 10 times or more in 10 seconds
EVAP pressure change during reference pressure
Less than 0.65 kPa-g (4.87 mmHg-g)
EVAP pressure
Less than 42.1 kPa-a (315.9 mmHg-a)
EVAP pressure
More than 123.8 kPa-a (928.4 mmHg-a)
2009 Toyota Tundra
2009 ENGINE PERFORMANCE Engine Control System (3UR-FBE) - Tundra
Fig. 176: Evaporative Emission Control System - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. CONFIRM DTC AND EVAP PRESSURE
a. Connect the Techstream to the DLC3.
b. Turn the ignition switch to ON (do not start the engine).
c. Turn the Techstream ON.
d. Enter the following menus: Powertrain/Engine and ECT/Trouble Codes.
e. Read DTCs.
f. Enter the following menus: Powertrain/Engine and ECT/Data List/EVAP/Vapor Pressure Pump.
g. Read the EVAP (Evaporative Emission) pressure displayed on the Techstream.
Result
RESULT REFERENCE
NOTE:
When a vehicle is brought into the workshop, leave it as it is. Do not
change the vehicle condition. For example, do not tighten the fuel cap.
Do not disassemble the canister pump module.
The Techstream is required to conduct the following diagnostic
troubleshooting procedure.
Display (DTC
Output)
Test Result
Suspected Trouble Area
Proceed
to
2009 Toyota Tundra
2009 ENGINE PERFORMANCE Engine Control System (3UR-FBE) - Tundra
B: Go to step 4
C: GO TO EVAP SYSTEM
A: Go to Next Step
2. CHECK HARNESS AND CONNECTOR (CANISTER PUMP MODULE - ECM)
a. Turn the ignition switch off.
b. Disconnect the D74 ECM connector.
Fig. 177: Identifying Terminals Of D74 ECM Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c. Measure the resistance according to the value(s) in the table below.
Result
RESISTANCE SPECIFIED CONDITION RESULT REFERENCE
P0451
-
Canister pressure sensor
C
P0452
Less than 45 kPa-a
(430 mmHg-a)
Wire harness/connector (ECM -
Canister pressure sensor)
Canister pressure sensor
Short in ECM circuit
A
P0453
More than 120 kPa-a
(900 mmHg-a)
Wire harness/connector (ECM -
Canister pressure sensor)
Canister pressure sensor
Open in ECM circuit
B
Tester Connection Condition
Specified
Condition
Suspected Trouble Area
Proceed
to
D74-121 (PPMP) -
Body ground
Always
10 ohms or
less
Wire harness/connector (ECM -
Canister pressure sensor)
Short in canister pressure sensor
circuit
A
2009 Toyota Tundra
2009 ENGINE PERFORMANCE Engine Control System (3UR-FBE) - Tundra
B: Go to step 7
A: Go to Next Step
3. CHECK HARNESS AND CONNECTOR (CANISTER PUMP MODULE - ECM)
a. Disconnect the R1 canister pump module connector.
Fig. 178: Identifying R1 Canister Pump Module Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Disconnect the D74 ECM connector.
c. Measure the resistance according to the value(s) in the table below.
Result
RESISTANCE SPECIFIED CONDITION RESULT REFERENCE
D74-121 (PPMP) -
Body ground
Always
10 kohms or
more
Wire harness/connector (ECM -
Canister pressure sensor)
Short in ECM circuit
B
Tester Connection Condition
Specified
Condition
Suspected Trouble Area
Proceed
to
D74-121 (PPMP) -
Body ground
Always
10 kohms or
more
Short in canister pressure sensor circuit
A
D74-121 (PPMP) -
Body ground
Always
10 ohms or
less
Short in wire harness/connector (ECM
- Canister pressure sensor)
B
2009 Toyota Tundra
2009 ENGINE PERFORMANCE Engine Control System (3UR-FBE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст