Toyota Tundra. Manual — part 2046
Fig. 379: Tightening Camshaft Timing Exhaust Gear Bolt - RH
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
37
CHECK NO. 1 CYLINDER TO TDC/COMPRESSION
a
Temporarily install the pulley set bolt
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
b
Rotate the crankshaft clockwise, and check that the timing marks on the crankshaft timing gear and
camshaft timing gears are as shown in the illustration
c
Remove the crankshaft pulley bolt
Fig. 380: Identifying Timing Mark And Knock Pin Positions
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
38
INSTALL WATER INLET PIPE (See INSTALLATION )
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
39
INSTALL TIMING CHAIN COVER SUB-ASSEMBLY (See INSTALLATION )
40
INSTALL WATER PUMP ASSEMBLY (See INSTALLATION )
41
INSTALL FRONT CRANKSHAFT OIL SEAL
a
Apply MP grease to the lip of a new oil seal
b
Using SST and a hammer, tap in the oil seal to a depth between 0 to 1 0 mm (0 to 0 0394 in ) from
the timing chain cover edge
SST 09223-22010, 09506-35010
NOTE:
Keep the lip free from foreign matter.
Do not tap oil seal at an angle.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
42
INSTALL CRANKSHAFT TIMING GEAR KEY
a
Install the crankshaft timing gear key to the crankshaft
Fig. 381: Installing Front Crankshaft Oil Seal
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст