Toyota Tundra. Manual — part 507
Fig. 153: Checking Map Disc For Deformed Or Cracked
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
OK: No deformations or cracks on map disc.
NG: REPLACE MAP DISC
OK: Go to Next Step
2. CHECK NAVIGATION DISPLAY
a. Check that displays other than the navigation display are complete.
OK: No other incomplete displays are found.
Result
NAVIGATION DISPLAY RESULT CHART
B: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Floor Shift Type) )
C: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
A: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Column Shift Type) )
ROUTE CANNOT BE CALCULATED
INSPECTION PROCEDURE
1. CHECK MAP DISC
a. Check that the map disc is not deformed or cracked.
Result
Proceed to
OK (for Column Shift Type)
A
OK (for Floor Shift Type)
B
NG
C
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
Fig. 154: Checking Map Disc For Deformed Or Cracked
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
OK: No deformations or cracks on map disc.
NG: REPLACE MAP DISC
OK: Go to Next Step
2. SET DESTINATION
a. Set another destination and check if the system can calculate the route correctly.
OK: Route can be correctly calculated.
NG: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE
OK: END
VOICE RECOGNITION DIFFICULTY
INSPECTION PROCEDURE
1. CHECK CONDITION
a. Check if the system's voice recognition level is low by using only one particular voice.
OK: System's voice recognition level is low with any voice.
NG: SYSTEM'S VOICE RECOGNITION LEVEL VARIES DEPENDING ON VOICE AND
PRONUNCIATION. THIS IS NOT A MALFUNCTION.
OK: Go to Next Step
2. CHECK MAP DISC
a. Check that the map disc is not deformed or cracked.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
Fig. 155: Checking Map Disc For Deformed Or Cracked
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
OK: No deformations or cracks on map disc.
NG: REPLACE MAP DISC
OK: Go to Next Step
3. CHECK MAP DISC
a. Check for dirt on the map disc surface.
Fig. 156: Cleaning Disc Surface With Soft Cloth
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
OK: No dirt is on map disc surface.
HINT:
If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.
NG: CLEAN MAP DISC
OK: Go to Next Step
NOTE:
Do not use a conventional record cleaner or antistatic preservative.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
4. CHECK MICROPHONE (NAVIGATION CHECK MODE)
a. Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (see NAVIGATION
CHECK MODE ).
Fig. 157: Display - Microphone And Voice Recognition Check Mode
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. When a voice is input into the microphone, check that the microphone input level meter changes
according to the input voice.
c. Push the recording switch and perform voice recording.
HINT:
The recording limit is 5 seconds.
d. Check that the recording indicator remains on while recording and that the recorded voice is played
normally without noise or distortion.
OK: All check results are normal.
NG: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE
OK: END
VOICE IS NOT RECOGNIZED
INSPECTION PROCEDURE
1. CHECK NAVIGATION SETTINGS
a. Enter the "Menu" screen by pressing the "MENU" switch.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст