Toyota Tundra. Manual — part 1717
Fig. 84: Inspecting Purge VSV
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
If the result is not as specified, replace the purge VSV
b
Inspect the purge VSV operation
1
Check that air does not flow from ports
Fig. 85: Checking That Air Does Not Flow From Ports
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2
Apply battery voltage across the terminals
3
Check that air flows from ports
If operation is not as specified, replace the purge VSV
Tester Connection Condition Specified Condition
1-2
20°C (68°F)
26 to 30 ohms
1 - Body ground
Always
10 Mohms or higher
2 - Body ground
2009 Toyota Tundra
2009 ENG NE Emission Control (1GR-FE) - Tundra
Fig. 86: Applying Battery Voltage And Checking Air Flows From Ports
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSTALLATION
1
INSTALL PURGE VSV
a
Install the purge VSV with the bolt
Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)
Fig. 87: Identifying Purge VSV And Bolt
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Connect the 2 purge line hoses
c
Connect the purge VSV connector
Fig. 88: Identifying Purge VSV Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ENG NE Emission Control (1GR-FE) - Tundra
2
INSTALL V-BANK COVER (See INSTALLATION )
3
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
FUEL TANK CAP
INSPECTION
1
INSPECT FUEL TANK CAP ASSEMBLY
a
Visually check if the cap and gasket are deformed or damaged
If necessary, replace the cap assembly or gasket
Fig. 89: Inspecting Fuel Tank Cap Gasket
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
PCV VALVE
COMPONENTS
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
2009 Toyota Tundra
2009 ENG NE Emission Control (1GR-FE) - Tundra
Fig. 90: Identifying PCV Valve Components With Torque Specification
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1
DISCONNECT VENTILATION HOSE
2009 Toyota Tundra
2009 ENG NE Emission Control (1GR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст