Toyota Tundra. Manual — part 1959
Fig. 245: Locating Camshaft Oil Control Valve And Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
14
REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY LH (See REMOVAL )
15
REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY RH (See REMOVAL )
16
REMOVE OIL CONTROL VALVE FILTER
a
LH:
Remove the 3 bolts, cylinder head cover spacer, gasket and valve filter
Fig. 246: Locating LH Oil Control Valve Filter Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
RH:
Remove the 3 bolts, cylinder head cover spacer, gasket and valve filter
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Fig. 247: Locating RH Oil Control Valve Filter Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
17
REMOVE SPARK PLUG TUBE GASKET
a
Bend the 4 ventilation baffle plate claws on the cylinder head cover to an angle of 90° or more
b
Using a screwdriver, pry out the gaskets
HINT:
Be careful not to damage the gasket when removing it, as the removed gasket needs to be
used when installing a new one
Tape the screwdriver tip before use
Fig. 248: Removing Spark Plug Tube Gasket
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
18
REMOVE WATER PUMP ASSEMBLY (See REMOVAL )
19
REMOVE TIMING CHAIN COVER SUB-ASSEMBLY (See REMOVAL )
20
REMOVE WATER INLET PIPE (See DISASSEMBLY )
21
REMOVE FRONT CRANKSHAFT OIL SEAL
a
Place the timing chain cover on wooden blocks
b
Place the oil pump on a wooden block
NOTE:
Be careful not to damage the cylinder head cover.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
c
Using a screwdriver and wooden block, pry out the oil seal
HINT:
Tape the screwdriver tip before use
Fig. 249: Prying Out Oil Seal
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
22
SET NO. 1 CYLINDER TO TDC/COMPRESSION
a
Temporarily install the pulley set bolt
b
Rotate the crankshaft clockwise so that the timing marks on the crankshaft timing gear and
camshaft timing gears are as shown in the illustration
HINT:
If the timing marks do not align, rotate the crankshaft clockwise again and align the timing marks
NOTE:
Do not damage the surface of the oil seal press fit hole.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Fig. 250: Identifying Timing Marks On Crankshaft Timing Gear And Camshaft Timing Gear
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
23
REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY LH
a
Move the stopper plate upward to release the lock, and push the plunger deep into the tensioner
Fig. 251: Identifying Stopper Plate
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст