Toyota Tundra. Manual — part 2654
1. Remove the steering pad from the disc wheel.
2. Place the steering pad in a plastic bag, tie it tightly and dispose of it in the same way as other
general parts.
SPIRAL CABLE
COMPONENTS
Fig. 265: Identifying Spiral Cable Replacement Components (1 Of 3)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Do not apply water to a steering pad with a deployed
airbag.
Fig. 264: Disposing Steering Pad
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Always wash your hands with water after completing the
operation.
2009 Toyota Tundra
2009 RESTRAINTS Supplemental Restraint System - Tundra
Fig. 266: Identifying Spiral Cable Replacement Components (2 Of 3) With Torque Specifications
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Fig. 267: Identifying Spiral Cable Replacement Components (3 Of 3)
2009 Toyota Tundra
2009 RESTRAINTS Supplemental Restraint System - Tundra
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3. REMOVE LOWER NO. 3 STEERING WHEEL COVER (See REMOVAL )
4. REMOVE LOWER NO. 2 STEERING WHEEL COVER (See REMOVAL )
5. REMOVE STEERING PAD (See REMOVAL )
6. REMOVE STEERING WHEEL ASSEMBLY (See REMOVAL )
7. REMOVE LOWER STEERING COLUMN COVER (See REMOVAL )
8. REMOVE UPPER STEERING COLUMN COVER (See REMOVAL )
9. REMOVE SPIRAL CABLE
a. Disconnect the connectors from the spiral cable with steering sensor.
b. Detach the 3 claws and remove the spiral cable with steering sensor.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the
negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
NOTE:
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and settings. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).
NOTE:
When handling the airbag connector, take care not to damage the
airbag wire harness.
2009 Toyota Tundra
2009 RESTRAINTS Supplemental Restraint System - Tundra
Fig. 268: Identifying Spiral Cable With Steering Sensor Claws
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
10. REMOVE STEERING SENSOR
a. Detach the 6 claws and remove the sensor.
INSPECTION
1. REMOVE SPIRAL CABLE
a. If there are any defects as mentioned below, replace the spiral cable with a new one: Scratches,
cracks, dents or chips on the connector or the spiral cable.
Fig. 269: Identifying Steering Sensor Claws
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Check the spiral cable.
2009 Toyota Tundra
2009 RESTRAINTS Supplemental Restraint System - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст