Toyota Tundra. Manual — part 176
WIRING DIAGRAM
Fig. 121: Radio Receiver Power Source - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. INSPECT FUSE (RAD NO. 1)
a. Disconnect the RAD NO. 1 fuse from the engine room junction block.
b. Disconnect the ACC fuse from the main body ECU.
c. Measure the resistance according to the value(s) in the table below.
Standard resistance
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
TESTER CONNECTION SPECIFIED CONDITION
NG: REPLACE FUSE
OK: Go to Next Step
2. CHECK HARNESS AND CONNECTOR (RECEIVER - BATTERY AND BODY GROUND)
a. Disconnect the K1*1, K4*2 and K9*2 receiver connectors.
HINT:
*1: for Built-in Type Amplifier System
*2: for Separate Type Amplifier System
b. Measure the resistance according to the value(s) in the table below.
Standard resistance:
for Built-in Type Amplifier System
TESTER CONNECTION SPECIFIED CONDITION
for Separate Type Amplifier System
TESTER CONNECTION SPECIFIED CONDITION
c. Measure the voltage according to the value(s) in the table below.
Standard voltage:
for Built-in Type Amplifier System
TESTER CONNECTION SPECIFIED CONDITION
Tester Connection Condition Specified Condition
RAD NO. 1 fuse
Always
Below 1 ohms
ACC fuse
Tester Connection
Condition Specified Condition
K1-7 (GND) - Body ground Always
Below 1ohms
Tester Connection
Condition Specified Condition
K4-20 (GND) - Body ground
Always
Below 1 ohms
K9-14 (GND) - Body ground
Tester Connection
Switch Condition Specified Condition
K1-4 (B) - Body ground
Always
11 to 14 V
K1-3 (ACC) - Body ground Ignition switch ACC
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Fig. 122: Checking Harness And Connector (Receiver - Battery And Body Ground)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
for Separate Type Amplifier System
TESTER CONNECTION SPECIFIED CONDITION
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE (see PROBLEM SYMPTOMS TABLE )
Tester Connection
Switch Condition Specified Condition
K4-1 (B) - Body ground
Always
11 to 14 V
K9-5 (+B) - Body ground
K4-11 (ACC) - Body ground
Ignition switch ACC
K9-16 (ACC) - Body ground
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
STEREO COMPONENT AMPLIFIER POWER SOURCE CIRCUIT
DESCRIPTION
This circuit provides power to the stereo component amplifier.
WIRING DIAGRAM
Fig. 123: Stereo Component Amplifier Power Source - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. INSPECT FUSE (AMP, ACC)
a. Disconnect the AMP fuse from the engine room junction block.
b. Disconnect the ACC fuse from the main body ECU.
c. Measure the resistance according to the value(s) in the table below.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст