Toyota Tundra. Manual — part 963

Fig. 155: Locating Harness Clamps With Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

7. INSTALL FRONT WHEEL

Torque: for Aluminum Wheel

131 N*m (1336 kgf*cm, 97 ft.*lbf)

for Steel Wheel

209 N*m (2131 kgf*cm, 154 ft.*lbf)

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

9. CHECK SPEED SENSOR SIGNAL

a. Check the speed sensor signal (see TEST MODE PROCEDURE ).

REAR SPEED SENSOR

COMPONENTS

NOTE:

Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).

2009 Toyota Tundra

2009 BRAKES Brake Control - Tundra

Fig. 156: Identifying Rear Speed Sensor Replacement Components With Torque Specifications
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE REAR WHEEL

3. REMOVE REAR SPEED SENSOR LH

a. Disconnect the speed sensor connector (labeled A).

NOTE:



After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and settings. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.



Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).

2009 Toyota Tundra

2009 BRAKES Brake Control - Tundra

b. Remove the nut (labeled B) and speed sensor (labeled C).

Fig. 157: Locating Speed Sensor Connector And Nut
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

4. REMOVE REAR SPEED SENSOR RH

a. Disconnect the speed sensor connector (labeled A).

b. Remove the nut (labeled B) and speed sensor (labeled C).

5. REMOVE SKID CONTROL SENSOR WIRE

a. Disconnect the sensor connector (labeled A).

b. Detach the 7 clips (labeled B).

c. Remove the bolt (labeled C).

d. Remove the nut (labeled D) and skid control sensor wire.

Fig. 158: Locating Sensor Connector Clips, Bolt And Nut
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2009 Toyota Tundra

2009 BRAKES Brake Control - Tundra

Fig. 159: Locating Skid Control Sensor Wire
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

INSTALLATION

1. INSTALL SKID CONTROL SENSOR WIRE

a. Install the sensor clamp with the nut (labeled A).

Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf)

b. Install the sensor clamp with the bolt (labeled B).

Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf)

c. Attach the 7 clips (labeled C).

d. Connect the sensor connector (labeled D).

NOTE:

Make sure the clamp's rotation stopper touches the installation
position.

NOTE:

When installing the clamp, do not twist the wire harness.

NOTE:



When installing the clamps, do not twist the wire harness.



When installing the clamps, securely insert them as shown
below.

NOTE:

Securely connect the connector.

2009 Toyota Tundra

2009 BRAKES Brake Control - Tundra