Toyota Tundra. Manual — part 1734
Fig. 99: Identifying Wire Harness Clamp
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c
Connect the vent line hose
1
Push the hose into the port and push the retainer to lock it
Fig. 100: Pushing Hose Into Port
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
d
Connect the air inlet line hose
NOTE:
Check for damage or foreign objects on the connected
part.
After connecting, check that the vent hose and the valve
are securely connected by pulling on them.
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
e
Connect the purge line hose
f
Connect the pump module connector
g
Connect the wiring harness clamp bracket with the nut
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Fig. 101: Identifying Wiring Harness Clamp Bracket With Nut
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PURGE VALVE
COMPONENTS
NOTE:
Check for damage or foreign objects on the connected part.
After connecting, check that the vent hose and the valve are
securely connected by pulling on them.
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
Fig. 102: Identifying Purge Valve Components With Torque Specification
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
2
REMOVE PURGE VSV
a
Disconnect the purge VSV connector
Fig. 103: Identifying Purge VSV Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Disconnect the 2 purge line hoses
c
Remove the bolt and purge VSV
INSPECTION
1
INSPECT PURGE VSV
a
Measure the resistance according to the value(s) in the table below
Standard resistance
PURGE VSV STANDARD RESISTANCE SPECIFICATION
memory and settings. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
Tester Connection Condition Specified Condition
1 - 2
20°C (68°F)
23 to 26 ohms
1 - Body ground
Always
10 Mohms or higher
2 - Body ground
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст