Toyota Tundra. Manual — part 546
Fig. 310: Identifying K18 And K8 Receiver Connectors
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Result
NAVIGATION RECEIVER RESULT CHART
B: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Column Shift Type) )
C: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Floor Shift Type) )
A: Go to Next Step
3. IDENTIFY COMPONENT WHICH HAS STORED THIS CODE
a. Enter the diagnostic mode.
b. Press the "LAN Mon" switch to change to "LAN Monitor" mode.
c. Identify the component which has stored this code.
Component table
COMPONENT CHART
Result
Proceed to
OK
A
NG (for Column Shift Type)
B
NG (for Floor Shift Type)
C
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
Fig. 311: Diagnostic Menu Screen Display - LAN Monitor Mode
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
4. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMPONENT WHICH
HAS STORED THIS CODE)
Display
Component
DSP-AMP
Stereo component amplifier
Rr-TV*
Television display
HINT:
"DSP-AMP" is the component which has stored this code in the example shown in the
illustration.
*: w/ Rear Seat Entertainment System
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
HINT:
For details of the connectors, refer to "TERMINALS OF ECU" .
a. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the
navigation receiver and the component which has stored this code.
1. Disconnect all connectors between the navigation receiver and the component which has
stored this code.
2. Check for an open or short in the AVC-LAN circuit between the navigation receiver and the
component which has stored this code.
OK: There is no open or short circuit.
Fig. 312: AVC-LAN Wiring Diagram (W/O Rear Seat Entertainment System)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
Fig. 313: AVC-LAN Wiring Diagram (W/ Rear Seat Entertainment System)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to Next Step
5. REPLACE NAVIGATION RECEIVER
a. Replace the navigation receiver (for Column Shift Type) with a normal one (see REMOVAL ).
b. Replace the navigation receiver (for Floor Shift Type) with a normal one (see REMOVAL ).
c. Check if the same problem occurs again.
OK: Same problem does not occur.
NG: REPLACE COMPONENT WHICH HAS STORED THIS CODE
OK: END
DTC 01-E0 REGISTRATION COMPLETE INDICATION ERROR; DTC 01-E3 REGISTRATION
DEMAND TRANSMISSION; DTC 01-E4 MULTIPLE FRAME INCOMPLETE
DESCRIPTION
DTC TROUBLE DETECTION CONDITION CHART
DTC
DTC Detection Condition
Trouble
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Navigation - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст