Toyota Sequoia (2005). Manual — part 717
LU08Z–10
B07332
New O–Ring
B07837
–
LUBRICATION
OIL COOLER
LU–23
2857
INSTALLATION
1.
INSTALL OIL COOLER
(a)
Clean the oil cooler contact surface on the cooler mount-
ing.
(b)
Place a new O–ring to the oil cooler.
(c)
Apply a light coat of engine oil on the threads and under
the head of the union bolt.
(d)
Install the oil cooler and plate washer with the union bolt.
Torque: 68.6 N·m (700 kgf·cm, 51 ft·lbf)
(e)
Connect the 2 oil cooler hoses to the oil cooler.
2.
INSTALL OIL FILTER (See page
)
3.
FILL WITH ENGINE COOLANT
4.
START ENGINE AND CHECK FOR ENGINE OIL
LEAKS
5.
CHECK ENGINE OIL LEVEL
LU0IH–06
B17483
Piston
Connecting Rod Bearing
Connecting Rod Cap
Cylinder Block
Lower Main Bearing
Upper Crankshaft
Thrust Washer
Crankshaft
See page
1st 24.5 (250, 18)
2nd Turn 90
°
Upper Main Bearing
Lower Crankshaft
Thrust Washer
Main Bearing Cap
See page
1st 27 (275, 20)
2nd Turn 90
°
N·m (kgf·cm, ft·lbf)
: Specified torque
Non–reusable part
Oil Nozzle
9.0 (92, 80 in.·lbf)
LU–24
–
LUBRICATION
OIL NOZZLE
2858
OIL NOZZLE
COMPONENTS
LU0ID–05
B17484
–
LUBRICATION
OIL NOZZLE
LU–25
2859
REMOVAL
1.
REMOVE CRANKSHAFT (See page
2.
REMOVE OIL NOZZLE (WITH RELIEF VALVE)
Using a 5 mm hexagon wrench, remove the bolt and oil nozzle.
LU0IE–05
B17485
LU–26
–
LUBRICATION
OIL NOZZLE
2860
INSPECTION
INSPECT RELIEF VALVE (OIL NOZZLE)
Push the valve with a wooden stick to check if it is stuck.
If stuck, replace the relief valve.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст