Toyota Sequoia (2005). Manual — part 869
BE2MQ–01
Press E/M and Mode Switches
at the same time.
On Duration
Normal Mode
Pressed for 5 sec.
6. Zone Setting Mode
Ignition switch ON.
Pressed for 10 sec.
Zone area +1
E/M Switch ON
7. Calibration Mode
Leaving it untouched
for a while
Normal Mode
–
BODY ELECTRICAL
COMPASS
BE–61
3465
CALIBRATION
1.
SELECTING COMPASS DISPLAY MODE
The mode select switch allows you to select a Display or Non–display mode of the compass.
2.
SETTING ZONE
Deviation between the magnetic north and ”actual north” differs depending on the terrestrial location, there-
fore, an adjustment in magnetism is required. Since the magnetic condition differs according to the area
where the vehicle will be used, it is necessary for each user to set the zone. (Refer to ”Compass Zone Map”).
The zone setting can be changed using the E/M switch of the display.
3.
PERFORMING CALIBRATION
Because each vehicle has its own magnetic field, calibration should be performed for each vehicle. This com-
pass function is used when storing the record of the vehicle’s magnetic field.
4.
WHEN COMPASS MAGNETIZED:
A compass could be magnetized during shipping by vessels or freight cars. Before delivery, therefore, make
sure to perform calibration and ensure that calibration can be done. If it cannot be done (cannot complete
in spite of driving round several times), it may be caused by magnetization. Demagnetize the vehicle using
a demagnetizer and perform calibration again.
5.
SETTING COMPASS
I28770
BE–62
–
BODY ELECTRICAL
COMPASS
3466
6.
ZONE SETTING MODE
(a)
Turn the ignition switch ON.
(b)
Keep pressing the E/M switch and MODE switch for 5 sec. when outer temperature is displayed, will
activate zone setting mode, showing a number (1–15) on the compass display.
–
BODY ELECTRICAL
COMPASS
BE–63
3467
HINT:
In the initial status, ”8” is displayed.
(c)
The displayed number increases +1 every time the E/M switch is pressed. Referring to the map, check
the number for the area where the vehicle will be used and set the zone number.
(d)
Leave it untouched for several seconds after setting and check that the compass display shows an
azimuthal direction (N, NE, E, SE, S, SW, W, or NW) or ”VAR”.
7.
CALIBRATION SETTING MODE
(a)
After the set zone is displayed, if the E/M switch and MODE switch remains pressed for another 5 se-
conds, calibration setting mode will be activated.
(b)
Keep pressing the E/M switch and MODE switch for 10 sec. when outer temperature is displayed will
also activate this mode.
(c)
Drive the vehicle at a speed of 5 MPH (8 km/h) or less in a circle.
(d)
Driving in a circle 1 to 3 times will display the azimuthal direction on the display, completing the calibra-
tion.
HINT:
Once calibration is completed, it is not necessary to perform the above procedures unless the magnetic field
strength is drastically changed. If this happens, the azimuthal display will be changed to ”CAL”.
BE0TC–09
I28412
Mirror Assembly
Mirror Heater
Rear Window Defogger
Instrument Panel J/B
MIRROR HEATER Relay
Ignition Switch
Rear Defogger Switch
Engine Room J/B
DEFOG Relay
MIR HTR Fuse
BE–64
–
BODY ELECTRICAL
DEFOGGER SYSTEM
3468
DEFOGGER SYSTEM
LOCATION
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст