Toyota Sequoia (2005). Manual — part 946
I21390
X10
AC3HC–02
I21395
Marking A
B
I21396
Marking B
AC–46
–
AIR CONDITIONING
REAR A/C UNIT
3773
REASSEMBLY
1.
ASSEMBLE REAR A/C UNIT
(a)
Install the insulator and heater radiator.
(b)
Install the shaft and sliding door.
(c)
Assemble the A/C unit and install the 10 screws.
(d)
Install the blower case, clamp and 2 screws.
2.
INSTALL AIR OUTLET SERVOMOTOR
(a)
Align marking A on the grid part of the case with the side
of sliding door rack B.
(b)
Install the servomotor with the 3 screws.
HINT:
The projection on the gear (marking B) shall be positioned verti-
cally.
3.
INSTALL EVAPORATOR
4.
INSTALL EXPANSION VALVE
5.
INSTALL WATER VALVE
6.
INSTALL THERMISTOR
7.
INSTALL POWER TRANSISTOR
8.
INSTALL BLOWER MOTOR
AC3HD–01
–
AIR CONDITIONING
REAR A/C UNIT
AC–47
3774
INSTALLATION
Installation is in the reverse order of removal (See page
AC1KT–05
I21425
Lower LH
Finish Panel
Cooling Unit
Blower Unit
Air Inlet Servomotor
Blower Motor
Heater to Register
Duct No. 4
Front Door Scuff Plate RH
Blower Unit Case
Lower Cover
Lower No. 2
Finish Panel
Glove Compartment Door
Cowl Side
Trim RH
Front
Console
Box
Console
Upper Panel
Rear
Console Box
AC–48
–
AIR CONDITIONING
BLOWER UNIT
3775
BLOWER UNIT
COMPONENTS
AC1KU–06
I21448
–
AIR CONDITIONING
BLOWER UNIT
AC–49
3776
REMOVAL
1.
REMOVE CONSOLE UPPER PANEL
2.
REMOVE REAR CONSOLE BOX
3.
REMOVE FRONT CONSOLE BOX
4.
REMOVE LOWER LH FINISH PANEL
5.
REMOVE GLOVE COMPARTMENT DOOR
6.
REMOVE LOWER NO. 2 FINISH PANEL
7.
REMOVE LOWER COVER
8.
9.
REMOVE BLOWER UNIT
(a)
Disconnect the connector from the blower motor.
(b)
Disconnect the connector from the air inlet servomotor.
(c)
Remove the nut, bolt and blower unit.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст