Toyota Sequoia (2005). Manual — part 720
IG08U–08
B17487
IG–8
–
IGNITION
CAMSHAFT POSITION SENSOR
2869
REMOVAL
1.
DRAIN ENGINE COOLANT
2.
REMOVE DRIVE BELT (See page
)
3.
REMOVE LH NO.3 TIMING BELT COVER
(See page
4.
REMOVE CAMSHAFT POSITION SENSOR
Remove the bolt, stud bolt and camshaft position sensor.
IG08V–06
B17487
–
IGNITION
CAMSHAFT POSITION SENSOR
IG–9
2870
INSTALLATION
1.
INSTALL CAMSHAFT POSITION SENSOR
Install the camshaft position sensor with the bolt and stud bolt
Torque: 7.5 N·m (80 kgf·cm, 66 in.·lbf)
2.
INSTALL LH NO.3 TIMING BELT COVER
(See page
3.
INSTALL DRIVE BELT (See page
)
4.
)
5.
CHECK ENGINE COOLANT FOR LEAKS
6.
CHECK IGNITION TIMING (See page
)
IG08W–06
B07249
N·m (kgf·cm, ft·lbf) : Specified torque
Crankshaft Position Sensor
Engine Under Cover (2WD)
Crankshaft Position
Sensor Connector
Engine Under Cover (4WD)
x 5
6.5 (65, 58 in.·lbf)
29 (296, 21)
29 (296, 21)
IG–10
–
IGNITION
CRANKSHAFT POSITION SENSOR
2871
CRANKSHAFT POSITION SENSOR
COMPONENTS
IG08X–05
B07251
–
IGNITION
CRANKSHAFT POSITION SENSOR
IG–11
2872
REMOVAL
1.
REMOVE ENGINE UNDER COVER
2.
REMOVE CRANKSHAFT POSITION SENSOR
(a)
Disconnect the crankshaft position sensor connector.
(b)
Remove the bolt and crankshaft position sensor.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст