Toyota Tundra (2015 year). Manual — part 2667
(c) Using SST and a press, press in a new bearing.
SST: 09950-60010
09951-00470
SST: 09950-70010
09951-07100
(d) Install the retainer plate with the 4 screws.
Torque:
2.3 N·m {23 kgf·cm, 20in·lbf}
5. INSPECT GENERATOR ROTOR BEARING
(a) When rotating the bearing, check that there is no abnormal noise
and that it rotates smoothly.
If necessary, replace the generator rotor.
3UR-FE CHARGING: GENERATOR: INSPECTION; 2015 MY Tundra [...
Last Modified: 9-16-2014
6.6 L
Doc ID: RM000002VSZ00WX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: PRECAUTION; 2015 MY Tundra [08/2014 - ]
PRECAUTION
1. STEERING SYSTEM HANDLING PRECAUTIONS
2. SRS AIRBAG SYSTEM HANDLING PRECAUTIONS
(a) This vehicle is equipped with an SRS (Supplemental Restraint System), which includes components such as
the driver airbag and front passenger side airbag. Failure to carry out service operations in the correct
sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident.
.
3. BUS LINE REPAIR
(a) After repairing the bus line with solder, wrap the repaired part
with vinyl tape
.
NOTICE:
The CANL bus line and CANH bus line must be installed together.
When installing the CAN bus lines, make sure to twist them.
CAN bus lines are likely to be influenced by noise if the bus lines
are not twisted together.
Leave approximately 80 mm (3.15 in.) loose in the twisted wires
around the connectors.
(b) Do not use by-pass wiring between the connectors.
NOTICE:
Text in Illustration
*1
By-pass Wire
4. CONNECTOR HANDLING
(a) When inserting probes into a connector, insert them from the
*1
Tester Probe
CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: PRE...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст