Toyota Tundra (2015 year). Manual — part 129
NEXT
NEXT
NEXT
Last Modified: 9-16-2014
6.6 D
Doc ID: RM000004RRW01PX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: HOW TO PROCEED WITH
TROUBLESHOOTING; 2015 MY Tundra [08/2014 - ]
HOW TO PROCEED WITH TROUBLESHOOTING
HINT:
Use the following procedure to troubleshoot the blind spot monitor system.
*: Use the Techstream.
1.
VEHICLE BROUGHT TO WORKSHOP
2.
CUSTOMER PROBLEM ANALYSIS
3.
INSPECT BATTERY VOLTAGE
(a) Measure the battery voltage.
Standard voltage:
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
4.
CHECK CAN COMMUNICATION SYSTEM*
(a) Use the Techstream to check if the CAN communication system is functioning normally
.
Result
RESULT
PROCEED TO
PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM...
A
A
NEXT
RESULT
PROCEED TO
CAN communication system DTC is not output.
A
CAN communication system DTC is output.
B
B
GO TO CAN COMMUNICATION SYSTEM
5.
CHECK FOR DTC AND FREEZE FRAME DATA*
(a) Refer to DTC Check / Clear for the blind spot monitor system
.
(b) Record or print DTCs and freeze frame data, if necessary
.
Result
RESULT
PROCEED TO
DTCs are output.
A
DTCs are not output.
B
B
Go to step 9
6.
CLEAR DTC*
(a) Refer to DTC Check / Clear for the blind spot monitor system
.
HINT:
The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.
7.
RECHECK FOR DTC*
PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM...
A
A
(a) Refer to DTC Check / Clear for the blind spot monitor system
.
Result
RESULT
PROCEED TO
DTCs are output.
A
DTCs are not output.
B
HINT:
Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores
history DTCs.
B
Go to step 9
8.
DIAGNOSTIC TROUBLE CODE CHART
(a) Find the output DTC in Diagnostic Trouble Code Chart
.
NEXT
Go to step 11
9.
PROBLEM SYMPTOMS TABLE
(a) Refer to Problem Symptoms Table
.
Result
RESULT
PROCEED TO
Fault is not listed in Problem Symptoms Table.
A
Fault is listed in Problem Symptoms Table.
B
HINT:
If the symptom does not recur and no DTC is output, attempt to reproduce the symptoms
.
B
ADJUST, REPAIR OR REPLACE IN ACCORDANCE
WITH PROBLEM SYMPTOMS TABLE
PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM...
NEXT
NEXT
NEXT
NEXT
10.
PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM*
.
(b) Refer to Data List / Active Test
.
11.
CIRCUIT INSPECTION
12.
ADJUST, REPAIR OR REPLACE
13.
PERFORM BEAM AXIS INSPECTION AND CONFIRMATION
(a) Enter Test Mode (refer to Blind Spot Monitor Beam Axis Inspection)
.
(b) Confirm the blind spot monitor beam axis display and perform the blind spot monitor beam axis
adjustment
.
14.
PERFORM CONFIRMATION TEST*
NEXT
END
PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст