Toyota Tundra (2015 year). Manual — part 1147
OK
NEXT
OK:
EGR valve is tightly closed.
HINT:
Perform "Inspection After Repair" after replacing the EGR valve assembly
.
NG
REPLACE EGR VALVE ASSEMBLY
18.
CHECK HARNESS AND CONNECTOR
.
HINT:
Repair any problems.
19.
CHECK WHETHER DTC OUTPUT RECURS
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Clear the DTCs
.
(e) Turn the ignition switch off.
(f) Turn the ignition switch to ON and turn the Techstream on.
(g) Start the engine and warm it up.
(h) Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
(i) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(j) Read DTCs.
Result
RESULT
PROCEED TO
1UR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P0171,P0172,...
A
RESULT
PROCEED TO
DTC P0171, P0172, P0174 or P0175 is output
A
DTC is not output
B
B
END
20.
CHECK HARNESS AND CONNECTOR (MASS AIR FLOW METER - ECM)
(a) Disconnect the mass air flow meter connector.
(b) Disconnect the ECM connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
D7-3 (VG) - D74-74 (VG)
Always
Below 1 Ω
D7-2 (E2G) - D74-75 (E2G)
Always
Below 1 Ω
D7-3 (VG) or D74-74 (VG) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
1UR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P0171,P0172,...
OK
NEXT
21.
REPLACE MASS AIR FLOW METER
(a) Replace the mass air flow meter
.
HINT:
.
22.
CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Clear the DTCs
.
(e) Turn the ignition switch off.
(f) Turn the ignition switch to ON and turn the Techstream on.
(g) Start the engine and warm it up.
(h) Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
(i) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(j) Read DTCs.
Result
RESULT
PROCEED TO
DTC is not output
A
DTC P0171, P0172, P0174 or P0175 is output
B
B
REPLACE ECM
A
END
1UR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P0171,P0172,...
OK
23.
CHECK HARNESS AND CONNECTOR (AIR FUEL RATIO SENSOR - INTEGRATION RELAY)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
24.
INSPECT INTEGRATION RELAY (A/F)
(a) Inspect the integration relay (A/F)
.
NG
REPLACE INTEGRATION RELAY
OK
CHECK ECM POWER SOURCE CIRCUIT
1UR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P0171,P0172,...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст