Toyota Tundra (2015 year). Manual — part 541
(b) The ECM records freeze frame data at 5 different times: 1) 3
times before the DTC is set, 2) once when the DTC is set, and 3)
once after the DTC is set. These data can be used to simulate
the vehicle's condition around the time when the malfunction
or not.
5. CHECK DATA LINK CONNECTOR 3 (DLC3)
6. CHECK MIL
(a) Check that the MIL illuminates when turning the ignition switch to ON.
If the MIL does not illuminate, there is a problem in the MIL circuit
.
(b) When the engine is started, the MIL should turn off.
AB60E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
Last Modified: 9-16-2014
6.6 D
Doc ID: RM000000W770ZQX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: AB60E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION SYSTEM: DTC CHECK / CLEAR; 2015
MY Tundra [08/2014 - ]
DTC CHECK / CLEAR
NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze
Pending DTC
Store
condition
Malfunction detected
Clear
condition
System determined to be normal
or
DTCs cleared using Techstream
or
Cable disconnected from negative battery terminal
Current DTC
Store
condition
Malfunction detected (2nd trip)
Clear
condition
No malfunctions in 40 driving cycles
or
DTCs cleared using Techstream
or
Cable disconnected from negative battery terminal
Permanent
DTC
Store
condition
Malfunction detected (2nd trip)
Clear
condition
Ignition switch turned to ON after no malfunction is detected in 3 consecutive
driving cycles
or
After DTCs cleared using Techstream or cable disconnected from negative battery
terminal, malfunction not detected when universal trip driving performed
MIL
ON
Malfunction detected (2nd trip)
AB60E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
OFF
Ignition switch turned to ON after no malfunction is detected in 3 consecutive
driving cycles
or
DTCs cleared using Techstream
or
Cable disconnected from negative battery terminal
AB60E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(e) Check the DTC(s) and freeze frame data, and then write them down.
.
2. CLEAR DTC (Pending and Current DTC)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(e) Clear the DTCs.
AB60E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст