Toyota Tundra (2015 year). Manual — part 2192
TERMINAL NO.
(SYMBOLS)
WIRING
COLOR
TERMINAL DESCRIPTION
CONDITION
SPECIFIED
CONDITION
DA-1 (IG) - Body
ground
B - Body
ground
IG power supply
Always
11 to 14 V
DB-21 (GND1) - Body
ground
B - Body
ground
Body ground
Always
Below 1 Ω
DB-21 (GND2) - Body
ground
B - Body
ground
Body ground
Always
Below 1 Ω
J4-24 (DCTY) - Body
ground
GR - Body
ground
Front door courtesy light switch
LH signal
Front door LH
open
Below 1 Ω
Front door LH
closed
10 kΩ or higher
J3-21 (PCTY) - Body
ground
W - Body
ground
Front door courtesy light switch
RH signal
Front door RH
open
Below 1 Ω
Front door RH
closed
10 kΩ or higher
If the result is not as specified, there may be a malfunction on the wire harness side.
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
Last Modified: 9-16-2014
6.6 U
Doc ID: RM0000027QL04CX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL SYSTEM (w/o Jam Protection Function):
DATA LIST / ACTIVE TEST; 2015 MY Tundra [08/2014 - ]
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely
on these reference values when deciding whether a part is faulty or not.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List.
(e) According to the display on the Techstream, read the Data List.
Main Body:
TESTER
DISPLAY
MEASUREMENT ITEM/RANGE
NORMAL CONDITION
DIAGNOSTIC
NOTE
D Door Courtesy
SW
Driver side door courtesy switch signal / ON or
OFF
ON: Driver door open
OFF: Driver door closed
-
P Door Courtesy
SW
Front passenger side door courtesy switch
signal / ON or OFF
ON: Front passenger door
open
OFF: Front passenger door
closed
-
2. ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be
operated without removing any parts. This non-intrusive functional inspection can be very useful because
intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early
in troubleshooting is one way to save diagnostic time. Data List information can be displayed while
performing Active Tests.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Active Test.
(e) According to the display on the Techstream, perform the Active Test.
Main Body:
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
TESTER DISPLAY
TEST PART
CONTROL
RANGE
DIAGNOSTIC
NOTE
IG OFF P/W Control Permission
Output
Power window control permission
output
ON or OFF
-
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
Last Modified: 9-16-2014
6.6 J
Doc ID: RM0000027QQ09WX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL SYSTEM (w/o Jam Protection Function):
Remote Up / Down Function does not Operate; 2015 MY Tundra [08/2014 - ]
Remote Up / Down Function does not Operate
DESCRIPTION
switch drives its respective power window regulator motor.
HINT:
The front passenger side power window and rear power windows*1, *2 cannot be operated when the
*2: for CrewMax
INSPECTION PROCEDURE
PROCEDURE
1.
CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (WINDOW LOCK
SWITCH)
(a) Turn the window lock switch OFF and operate the switches on
the master switch. Check that the remote UP/DOWN function
operates normally.
OK:
Remote UP/DOWN function operates normally.
NG
REPLACE POWER WINDOW REGULATOR MASTER
SWITCH ASSEMBLY
OK
END
WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст