Toyota Tundra (2015 year). Manual — part 339
INSPECTION PROCEDURE
NOTICE:
Perform the universal trip to clear permanent DTCs
.
1. DATA LIST
HINT:
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely
on these reference values when deciding whether a part is faulty or not.
(a) Warm up the engine.
(b) Turn the ignition switch off.
(c) Connect the Techstream to the DLC3.
(d) Turn the ignition switch to ON.
(e) Turn the Techstream on.
(f) Enter the following menus: Powertrain / Engine and ECT / Data List.
(g) According to the display on the Techstream, read the Data List.
Engine and ECT
TESTER
DISPLAY
MEASUREMENT
ITEM/RANGE
NORMAL CONDITION
DIAGNOSTIC
NOTE
SPD (SP2)
Output shaft speed/
Min.: 0 km/h (0 mph)
Max.: 255 km/h (158
Vehicle stopped: 0 km/h (0 mph) (output shaft
speed equal to vehicle speed)
-
A760E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
OK
TESTER
DISPLAY
MEASUREMENT
ITEM/RANGE
NORMAL CONDITION
DIAGNOSTIC
NOTE
mph)
HINT:
SPD (SP2) is always 0 while driving:
Open or short in the sensor or circuit.
The SPD (SP2) value displayed on the Techstream is much lower than the actual vehicle speed:
1.
INSPECT SPEED SENSOR SP2 INSTALLATION
(a) Check the speed sensor SP2 installation.
OK:
The installation bolt is tightened properly and there is no
clearance between the sensor and transmission case.
Text in Illustration
*a
CORRECT
*b
INCORRECT
NG
SECURELY INSTALL OR REPLACE SPEED SENSOR
SP2
2.
INSPECT SPEED SENSOR SP2
(a) Disconnect the D66 speed sensor connector.
(b) Measure the resistance according to the value(s) in the table below.
A760E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
OK
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
1 - 2
20°C (68°F)
560 to 680 Ω
Text in Illustration
*a
Component without harness connected
(Speed Sensor SP2)
NG
REPLACE SPEED SENSOR SP2
3.
CHECK HARNESS AND CONNECTOR (SPEED SENSOR SP2 - ECM)
(a) Disconnect the D74 ECM connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
D74-101 (SP2+) - D74-100 (SP2-)
20°C (68°F)
560 to 680 Ω
D74-101 (SP2+) - Body ground
Always
10 kΩ or higher
D74-100 (SP2-) - Body ground
Always
10 kΩ or higher
Text in Illustration
*a
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE ECM
A760E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
A760E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст