Toyota Tundra (2015 year). Manual — part 434
Last Modified: 9-16-2014
6.6 D
Doc ID: RM000000W770ZPX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: A760F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION SYSTEM: DTC CHECK / CLEAR; 2015
MY Tundra [08/2014 - ]
DTC CHECK / CLEAR
NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze
Pending DTC
Store
condition
Malfunction detected
Clear
condition
System determined to be normal
or
DTCs cleared using Techstream
or
Cable disconnected from negative battery terminal
Current DTC
Store
condition
Malfunction detected (2nd trip)
Clear
condition
No malfunctions in 40 driving cycles
or
DTCs cleared using Techstream
or
Cable disconnected from negative battery terminal
Permanent
DTC
Store
condition
Malfunction detected (2nd trip)
Clear
condition
Ignition switch turned to ON after no malfunction is detected in 3 consecutive
driving cycles
or
After DTCs cleared using Techstream or cable disconnected from negative battery
terminal, malfunction not detected when universal trip driving performed
MIL
ON
Malfunction detected (2nd trip)
A760F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISS...
OFF
Ignition switch turned to ON after no malfunction is detected in 3 consecutive
driving cycles
or
DTCs cleared using Techstream
or
Cable disconnected from negative battery terminal
A760F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISS...
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(e) Check the DTC(s) and freeze frame data, and then write them down.
.
2. CLEAR DTC (Pending and Current DTC)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(e) Clear the DTCs.
A760F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISS...
3. CLEAR DTC (Pending and Current DTC without using Techstream)
(2) Remove the EFI NO. 1 and ETCS fuses from the engine room relay block located inside the engine
compartment for more than 1 minute.
4. CLEAR PERMANENT DTC
HINT:
Even if the following procedure is not performed, permanent DTCs are cleared if no malfunction is detected
during 3 consecutive driving cycles.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(e) Check if permanent DTCs are stored.
HINT:
If permanent DTCs are not output, it is not necessary to continue this procedure.
(f) Clear DTCs.
(g) Perform the universal trip.
Idle the engine for 30 seconds or more.
1.
It is possible to complete the drive pattern even if the vehicle decelerates to less than 40
used in order and no gears are skipped.
2.
Allow 10 minutes or more to elapse from the time the engine is started.
3.
A760F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISS...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст