Toyota Tundra (2015 year). Manual — part 119
OK
A
REPLACE NAVIGATION RECEIVER ASSEMBLY
3.
CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY -
PARK/NEUTRAL POSITION SWITCH ASSEMBLY)
(a) Disconnect the J135 navigation receiver assembly connector.
(b) Disconnect the D35 park/neutral position switch assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
J135-2 (REV) - D35-1 (RL)
Always
Below 1 Ω
J135-2 (REV) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
4.
CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH ASSEMBLY -
BATTERY)
(a) Disconnect the park/neutral position switch assembly
connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION
SWITCH CONDITION
SPECIFIED CONDITION
D35-2 (RB) - Body ground
Ignition switch ON
11 to 14 V
Text in Illustration
*a
(to Park/neutral Position Switch Assembly)
HINT:
If replacing the park/neutral position switch assembly, refer to the procedures below.
for A760E:
for A760F:
for AB60E:
for AB60F:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE PARK/NEUTRAL POSITION SWITCH
ASSEMBLY
NAVIGATION: NAVIGATION SYSTEM: Reverse Signal Circuit; 201...
Last Modified: 9-16-2014
6.6 J
Doc ID: RM0000020QJ08GX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: NAVIGATION: NAVIGATION SYSTEM: Navigation Voice Circuit; 2015 MY Tundra [08/2014 - ]
Navigation Voice Circuit
DESCRIPTION
This circuit is used when the voice guidance in the navigation system is on or an incoming cellular phone voice in
the "Bluetooth" hands-free system is heard.
Using this circuit, the navigation receiver assembly sends the signals to the stereo component amplifier assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1.
CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY- STEREO
COMPONENT AMPLIFIER ASSEMBLY)
(a) Disconnect the J134 navigation receiver assembly connector.
(b) Disconnect the J141 stereo component amplifier connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NAVIGATION: NAVIGATION SYSTEM: Navigation Voice Circuit; 20...
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
J141-23 (II1+) - J134-2 (RL+)
Always
Below 1 Ω
J141-22 (II1-) - J134-6 (RL-)
Always
Below 1 Ω
J141-23 (II1+) - Body ground
Always
10 kΩ or higher
J141-22 (II1-) - Body ground
Always
10 kΩ or higher
J141-6 (SLD) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN
PROBLEM SYMPTOMS TABLE
NAVIGATION: NAVIGATION SYSTEM: Navigation Voice Circuit; 20...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст