Toyota Tundra (2015 year). Manual — part 991
Text in Illustration
*A
for Standard
*B
for 12 Speakers
(a) Remove the 2 bolts.
(b) Disconnect the connector and remove the front No. 2 speaker assembly LH.
NOTICE:
Text in Illustration
*A
for Standard
*B
for 12 Speakers
(a) Remove the 2 bolts.
(b) Disconnect the connector and remove the front No. 2 speaker assembly RH.
NOTICE:
7. REMOVE NO. 1 SPEAKER HOLE COVER
Text in Illustration
*1
Protective Tape
(a) Apply protective tape as shown in the illustration.
(b) Using moulding remover B, detach the 8 clips and remove the
No. 1 speaker hole cover.
8. REMOVE FRONT NO. 4 SPEAKER ASSEMBLY (for 12 Speakers)
Text in Illustration
*A
for Standard
*B
for 12 Speakers
(a) Remove the 2 bolts.
(b) Disconnect the connector and remove the front No. 4 speaker assembly.
NOTICE:
Last Modified: 9-16-2014
6.6 G
Doc ID: RM000002ZY2011X
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: AUDIO / VISUAL: INSTRUMENT PANEL SPEAKER (for CrewMax): INSPECTION; 2015 MY Tundra [08/2014
- ]
INSPECTION
1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for Standard)
(a) When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a
new one and check that the malfunction disappears.
OK:
Malfunction disappears.
HINT:
Connect the connectors to the front No. 2 speaker assemblies.
When there is a possibility that either the right or left front No. 2 speaker assembly is defective, inspect by
interchanging the right one with the left one.
Perform the inspection above on both the LH and RH sides.
2. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 12
Speakers)
(a) Measure the resistance according to the value(s) in the table
below.
Standard resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
3 - 4
Always
1.5 to 2.5 Ω
3 - 1
Always
Below 1 Ω
4 - 2
If the result is not as specified, replace the front No. 2 speaker
assembly.
Text in Illustration
*a
Component without harness connected
(Front No. 2 Speaker Assembly)
3. INSPECT FRONT NO. 4 SPEAKER ASSEMBLY (for Standard)
(a) Temporarily replace the front No. 4 speaker assembly with a new or normally functioning one.
OK:
Malfunction disappears.
HINT:
Connect the connectors to the front No. 4 speaker assembly.
AUDIO / VISUAL: INSTRUMENT PANEL SPEAKER (for CrewMax)...
4. INSPECT FRONT NO. 4 SPEAKER ASSEMBLY (for 12
Speakers)
(a) Measure the resistance according to the value(s) in the table
below.
Standard resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
1 - 2
Always
1.5 to 2.1 Ω
If the result is not as specified, replace the front No. 4 speaker
assembly.
Text in Illustration
*a
Component without harness connected
(Front No. 4 Speaker Assembly)
AUDIO / VISUAL: INSTRUMENT PANEL SPEAKER (for CrewMax)...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст