Toyota Tundra (2015 year). Manual — part 2797
(a) Disconnect the 5 connectors from the combination switch with
spiral cable.
12. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab)
13. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax)
14. REMOVE COWL SIDE TRIM BOARD LH
15. REMOVE INSTRUMENT SIDE PANEL LH
16. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
17. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
18. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY
(a) Remove the bolt and air duct.
19. REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY
STEERING COLUMN: STEERING COLUMN ASSEMBLY (for Power...
(a) Remove the 3 bolts and nut.
(b) Put matchmarks on the steering intermediate shaft and the
steering column.
Text in Illustration
*a
Matchmark
(c) Remove the bolt and steering intermediate shaft from the steering column.
(d) Put matchmarks on the No. 2 steering intermediate shaft and
steering intermediate shaft.
Text in Illustration
*a
Matchmark
(e) Remove the bolt and steering intermediate shaft from the No. 2 steering intermediate shaft.
20. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
(a) Put matchmarks on the No. 2 steering intermediate shaft and
power steering gear.
Text in Illustration
*a
Matchmark
(b) Remove the bolt and No. 2 steering intermediate shaft from the power steering gear.
21. REMOVE STEERING COLUMN ASSEMBLY
STEERING COLUMN: STEERING COLUMN ASSEMBLY (for Power...
(a) Remove the bolt and 2 nuts. Then remove the steering column
from the instrument panel reinforcement.
STEERING COLUMN: STEERING COLUMN ASSEMBLY (for Power...
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002ZQO01CX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: STEERING COLUMN: STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering
Column): DISASSEMBLY; 2015 MY Tundra [08/2014 - ]
DISASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU
(a) Disconnect the 2 ECU connectors.
(b) Remove the 2 screws and ECU.
2. REMOVE TRANSPONDER KEY AMPLIFIER
(a) Using a screwdriver, widen the claws attached to the upper
bracket by approximately 1.0 mm (0.0394 in.).
(b) Pull out the transponder key amplifier with the claws open.
NOTICE:
Using excessive force may damage the case.
3. REMOVE UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY
(a) Secure the steering column in a vise.
STEERING COLUMN: STEERING COLUMN ASSEMBLY (for Power...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст