Toyota Tundra (2015 year). Manual — part 1335
(a) Install the oil ring expander and 2 side rails by hand.
(b) Using a piston ring expander, install the 2 compression rings so that the paint marks are positioned as
shown in the illustration.
HINT:
ITEM
PAINT MARK
Type A
No. 1 Compression Ring
Blue
No. 2 Compression Ring
Orange
Type B
No. 1 Compression Ring
Yellow
No. 2 Compression Ring
Green
5. INSTALL CRANKSHAFT BEARING
1UR-FE ENGINE MECHANICAL: CYLINDER BLOCK: REASSEM...
NOTICE:
(1) Install the upper bearing to the cylinder block as shown in
the illustration.
NOTICE:
(c) Install the lower bearing.
NOTICE:
(2) Using a vernier caliper, measure the distance between the
bearing cap's edge and the lower bearing's edge.
Dimension A - B or B - A:
0 to 0.7 mm (0 to 0.0276 in.)
NOTICE:
Do not apply engine oil to the bearings and the contact surfaces.
Do not allow coolant to come into contact with the bearing inner
surface.
If any coolant comes into contact with the bearing inner surface,
replace the bearing with a new one.
6. INSTALL CRANKSHAFT THRUST WASHER SET
(a) Apply engine oil to the thrust washer set.
7. INSTALL CRANKSHAFT
(a) Apply engine oil to the upper bearing and lower bearing, then
place the crankshaft on the cylinder block.
1UR-FE ENGINE MECHANICAL: CYLINDER BLOCK: REASSEM...
HINT:
A number is marked on each main bearing cap to indicate the installation position.
(e) Insert the main bearing cap by hand until the clearance between
the main bearing cap and cylinder block is less than 6 mm
(0.236 in.) by marking the 2 internal bearing cap bolts as a
guide.
Bolt length:
91 mm (3.58 in.)
(f) Using a plastic-faced hammer, lightly tap the bearing cap to
ensure a proper fit.
positions.
Bolt length:
79.5 mm (3.13 in.)
HINT:
The main bearing cap bolts are tightened in 2 progressive steps.
(i) Step 1:
1UR-FE ENGINE MECHANICAL: CYLINDER BLOCK: REASSEM...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст