Toyota Tundra (2015 year). Manual — part 1382
(a) Disconnect the fuel tube sub-assembly from the fuel delivery
pipe sub-assembly RH (for Quick Type A)
.
(b) Disconnect the fuel tube sub-assembly from the fuel delivery
pipe sub-assembly LH (for Quick Type A)
.
7. DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
(a) Detach the clamp.
(b) Disconnect the No. 1 fuel pipe sub-assembly from the fuel delivery pipe sub-assembly LH (for Quick Type
B)
.
8. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY RH
(a) Disconnect the No. 6 wire harness connector.
(b) Remove the 2 bolts and fuel delivery pipe sub-assembly RH.
NOTICE:
When removing the fuel delivery pipe sub-assembly RH, hold the
pipe by both ends and pull it straight upward.
(c) Remove the 2 delivery pipe spacers and 4 insulators from the cylinder head sub-assembly RH.
9. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY LH
(a) Disconnect the No. 7 wire harness connector.
1UR-FE FUEL: FUEL INJECTOR: REMOVAL; 2015 MY Tundra [08/...
(b) Remove the 2 bolts and fuel delivery pipe sub-assembly LH.
NOTICE:
When removing the fuel delivery pipe sub-assembly LH, hold the
pipe by both ends and pull it straight upward.
(c) Remove the 2 delivery pipe spacers and 4 insulators from the cylinder head sub-assembly LH.
10. REMOVE FUEL INJECTOR ASSEMBLY
(a) Remove the fuel injector assembly from the fuel delivery pipe sub-assembly, and then disconnect the
injector connector.
NOTICE:
For reinstallation, attach a tag or label to the injector shaft.
(b) Remove the O-ring from the fuel injector assembly.
(c) Detach the 3 clamps and then remove the No. 6 wire harness
from the fuel delivery pipe sub-assembly RH.
1UR-FE FUEL: FUEL INJECTOR: REMOVAL; 2015 MY Tundra [08/...
(d) Detach the 3 clamps and then remove the No. 7 wire harness
from the fuel delivery pipe sub-assembly LH.
1UR-FE FUEL: FUEL INJECTOR: REMOVAL; 2015 MY Tundra [08/...
Last Modified: 9-16-2014
6.6 G
Doc ID: RM000000WQQ0AQX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: 1UR-FE FUEL: FUEL INJECTOR: INSPECTION; 2015 MY Tundra [08/2014 - ]
INSPECTION
1. INSPECT FUEL INJECTOR ASSEMBLY
(a) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
1 - 2
20°C (68°F)
11.6 to 12.4 Ω
If the result is not as specified, replace the injector assembly.
(b) Inspect the injection volume.
CAUTION:
(1) Remove the fuel pipe clamp.
(2) Disconnect the No. 1 fuel pipe sub-assembly (for Quick Type B)
.
(3) Connect SST to the fuel pipe (the vehicle side).
SST: 09268-31014
09268-41500
09268-41700
95336-08070
1UR-FE FUEL: FUEL INJECTOR: INSPECTION; 2015 MY Tundra [0...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст