Toyota Tundra (2015 year). Manual — part 371
Last Modified: 9-16-2014
6.6 A
Doc ID: RM0000013EZ06RX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: A760E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION UNIT: DISASSEMBLY; 2015 MY Tundra
[08/2014 - ]
DISASSEMBLY
1. REMOVE TRANSMISSION CONTROL SHAFT LEVER RH
(a) Remove the nut, spring washer and control shaft lever RH.
2. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(c) Remove the park/neutral position switch.
HINT:
Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral
position switch as the detent spring may become detached from the manual valve lever shaft.
3. REMOVE OIL COOLER TUBE UNION
(a) Remove the 2 oil cooler tube unions.
(b) Remove the O-ring from each oil cooler tube union.
A760E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
4. REMOVE SPEED SENSOR
(a) Remove the 2 bolts and 2 speed sensors.
(b) Remove the O-ring from each sensor.
5. REMOVE AUTOMATIC TRANSMISSION BREATHER TUBE
(a) Remove the 2 bolts.
(b) Remove the breather tube.
(c) Remove the O-ring from the tube.
6. REMOVE AUTOMATIC TRANSMISSION HOUSING
(a) Remove the 10 bolts and transmission housing.
7. REMOVE EXTENSION HOUSING SUB-ASSEMBLY
(a) Remove the 6 bolts.
A760E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
(b) Remove the extension housing.
HINT:
Using a brass bar and hammer, remove the extension housing.
(c) Using a snap ring expander, remove the snap ring.
(d) Remove the thrust needle roller bearing and 2 bearing races.
8. REMOVE EXTENSION HOUSING DUST DEFLECTOR
(a) Using a brass bar and hammer, tap off the dust deflector.
9. REMOVE EXTENSION HOUSING REAR OIL SEAL
(a) Using SST, tap out the oil seal.
SST: 09308-00010
10. FIX AUTOMATIC TRANSMISSION CASE SUB-ASSEMBLY
(a) Install the transmission case to an overhaul attachment.
11. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
(a) Remove the drain plug and gasket.
(b) Remove the overflow plug and gasket.
A760E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
(c) Remove the 20 bolts and oil pan.
NOTICE:
Do not turn the transmission over as this will contaminate the
13. REMOVE VALVE BODY OIL STRAINER ASSEMBLY
(a) Turn over the transmission.
(b) Remove the 4 bolts and oil strainer from the valve body.
(c) Remove the O-ring from the oil strainer.
14. REMOVE TRANSMISSION WIRE
(a) Remove the 2 bolts and 2 temperature sensor clamps.
(b) Disconnect the 2 ATF temperature sensors.
(c) Disconnect the 9 solenoid valve connectors.
(d) Detach the wire harness from the 2 clamps.
(e) Remove the bolt and pull out the transmission wire.
(f) Remove the O-ring from the transmission wire connector.
15. REMOVE TRANSMISSION VALVE BODY ASSEMBLY
A760E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст