Toyota Tundra (2015 year). Manual — part 421
HINT:
Detach the claw, press down the lever, and then disconnect the transmission wire connector.
(d) Detach the 4 connector clamps and 8 harness clamps.
(e) Remove the bolt, disconnect the harness clamp and wire harness.
16. DISCONNECT WATER BY-PASS PIPE
17. REMOVE TRANSMISSION OIL COOLER ASSEMBLY
18. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
(a) Remove the 10 bolts and transmission.
NOTICE:
Do not use excess force when prying the transmission assembly.
A760F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISS...
19. REMOVE HARNESS CLAMP BRACKET
(a) Remove the 5 bolts and 5 brackets.
20. REMOVE TRANSMISSION CONTROL CABLE BRACKET
(a) Remove the 2 bolts and bracket.
21. REMOVE TRANSFER ASSEMBLY
22. REMOVE TORQUE CONVERTER ASSEMBLY
(a) Remove the torque converter assembly from the automatic transmission assembly.
NOTICE:
Remove the torque converter assembly from the input shaft horizontally.
23. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY
A760F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISS...
Last Modified: 9-16-2014
6.6 A
Doc ID: RM0000018ZB058X
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: A760F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION ASSEMBLY: INSTALLATION; 2015 MY
Tundra [08/2014 - ]
INSTALLATION
1. INSTALL TORQUE CONVERTER ASSEMBLY
(a) Using a vernier caliper and straightedge, measure dimension "A" between the transmission fitting surface
Text in Illustration
*a
Matchmark
HINT:
Turn the torque converter approximately 180°.
Text in Illustration
*a
Matchmark
A760F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISS...
(d) Turn the torque converter and align the matchmarks on the
NOTICE:
Do not push on the torque converter when aligning the
matchmarks.
Text in Illustration
*a
Matchmark
(e) Using a vernier caliper and straightedge, measure dimension "B"
shown in the illustration and check that B is more than A
(measured in step 1).
Standard distance:
A + 1 mm (0.0394 in.) or more
2. INSTALL TRANSFER ASSEMBLY
3. INSTALL TRANSMISSION CONTROL CABLE BRACKET
(a) Install the bracket with the 2 bolts.
Torque:
12 N·m {122 kgf·cm, 9ft·lbf}
4. INSTALL WIRE HARNESS CLAMP BRACKET
(a) Install the 5 wire harness clamp brackets with the 5 bolts.
Torque:
for bolt A -
60 N·m {612 kgf·cm, 44ft·lbf}
Torque:
for bolt B -
8.0 N·m {82 kgf·cm, 71in·lbf}
5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
A760F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISS...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст