Toyota Tundra (2015 year). Manual — part 1405
Last Modified: 9-16-2014
6.6 G
Doc ID: RM0000031GR022X
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: 1UR-FE INTAKE: VACUUM SWITCHING VALVE (for ACIS): ON-VEHICLE INSPECTION; 2015 MY Tundra
[08/2014 - ]
ON-VEHICLE INSPECTION
1. REMOVE V-BANK COVER SUB-ASSEMBLY
2. INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
(a) Disconnect the vacuum switching valve connector.
(b) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
1 - 2
20°C (68°F)
37 to 44 Ω
1 - Body ground
Always
1 MΩ or higher
2 - Body ground
If the result is not as specified, replace the vacuum switching
valve assembly.
(c) Check the vacuum switching valve operation.
(1) When applying a vacuum to port E, check that air is sucked
into the filter.
1UR-FE INTAKE: VACUUM SWITCHING VALVE (for ACIS): ON-...
(2) Apply voltage across the terminals.
(3) When applying a vacuum to port F, check that air is sucked into port E.
If the result is not as specified, replace the vacuum switching valve assembly.
(d) Connect the vacuum switching valve connector.
3. INSTALL V-BANK COVER SUB-ASSEMBLY
1UR-FE INTAKE: VACUUM SWITCHING VALVE (for ACIS): ON-...
Last Modified: 9-16-2014
6.6 G
Doc ID: RM000002MQJ05UX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: 1UR-FE LUBRICATION: LUBRICATION SYSTEM: ON-VEHICLE INSPECTION; 2015 MY Tundra [08/2014 -
]
ON-VEHICLE INSPECTION
1. CHECK OIL QUALITY
(a) Check the oil for deterioration, water contamination, discoloring or thinning.
If the quality is visibly poor, replace the oil and oil filter element
.
2. CHECK ENGINE OIL LEVEL
(a) Warm up the engine, then stop the engine and wait for 5 minutes.
(b) Check that the engine oil level is between the low level and full level marks on the dipstick.
If low, check for leakage and add oil up to the full level mark.
NOTICE:
Do not fill engine oil above the full level mark.
HINT:
it difficult to judge the true level accurately.
3. INSPECT OIL PRESSURE
(a) Remove the oil pressure sender gauge
.
(b) Install an oil pressure gauge.
(c) Warm up the engine.
(d) Inspect the oil pressure.
Standard oil pressure:
CONDITION
SPECIFIED CONDITION
Idle
70 kPa (0.7 kgf/cm
2
, 10.1 psi) or higher
1UR-FE LUBRICATION: LUBRICATION SYSTEM: ON-VEHICLE ...
CONDITION
SPECIFIED CONDITION
2500 rpm
220 kPa (2.2 kgf/cm
2
, 32 psi) or higher
If the pressure is not as specified, check the oil pump
.
(e) Remove the oil pressure gauge.
(f) Install the oil pressure sender gauge
.
1UR-FE LUBRICATION: LUBRICATION SYSTEM: ON-VEHICLE ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст