Toyota Tundra (2015 year). Manual — part 673
Last Modified: 9-16-2014
6.6 D
Doc ID: RM000000W750RFX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: AB60F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION SYSTEM: SYSTEM DESCRIPTION; 2015
MY Tundra [08/2014 - ]
SYSTEM DESCRIPTION
1. SYSTEM DESCRIPTION
(a) The Electronic Controlled Automatic Transmission (ECT) is an automatic transmission that electronically
controls shift timing using the Engine Control Module (ECM). The ECM detects electrical signals that
indicate engine and driving conditions, and controls the shift point based on driver habits and road
conditions. As a result, fuel efficiency and power transmission performance are improved.
Shift shock is reduced by controlling the engine and transmission simultaneously.
In addition, the ECT has the following features:
Diagnostic function.
Fail-safe function when a malfunction occurs.
AB60F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
NEXT
NEXT
NEXT
NEXT
Last Modified: 9-16-2014
6.6 D
Doc ID: RM000000W6Z148X
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: AB60F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION SYSTEM: HOW TO PROCEED WITH
TROUBLESHOOTING; 2015 MY Tundra [08/2014 - ]
HOW TO PROCEED WITH TROUBLESHOOTING
HINT:
The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make
sure to check that there is no trouble in the CAN communication system.
*: Use the Techstream.
1.
VEHICLE BROUGHT TO WORKSHOP
2.
CUSTOMER PROBLEM ANALYSIS
(a) Refer to the How to Troubleshoot ECU Controlled Systems in Introduction section
.
3.
INSPECT BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
4.
CONNECT TECHSTREAM TO DLC3*
AB60F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
NEXT
NEXT
NEXT
A
5.
CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
(a) Refer to the DTC Check / Clear
.
6.
VISUAL INSPECTION
7.
SETTING CHECK MODE DIAGNOSIS*
(a) Refer to the Check Mode Procedure
.
8.
PROBLEM SYMPTOM CONFIRMATION
(a) Refer to the Road Test
.
Result
RESULT
PROCEED TO
Symptom does not occur
A
Symptom occurs
B
B
GO TO STEP 10
9.
SYMPTOM SIMULATION
AB60F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
NEXT
A
OK
(a) Refer to the Electronic Circuit Inspection Procedure
.
10.
DTC CHECK*
(a) Refer to the DTC Check / Clear
.
Result
RESULT
PROCEED TO
DTC is not output
A
DTC is output
B
B
GO TO STEP 18
11.
BASIC INSPECTION
(a) Refer to the Park/Neutral Position Switch
.
(b) Refer to the Shift Lever Assembly.
for Column Shift Type, refer to the following procedures
for Floor Shift Type, refer to the following procedures
NG
GO TO STEP 21
12.
MECHANICAL SYSTEM TESTS
(a) Refer to the Mechanical System Tests
.
NG
GO TO STEP 17
AB60F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMIS...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст