Toyota Tundra (2015 year). Manual — part 1925
OK
OK
OK
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
D39-1 (VVR+) - D74-87 (VV2+)
Always
Below 1 Ω
D39-2 (VVR-) - D74-88 (VV2-)
Always
Below 1 Ω
D37-1 (VVL+) or D74-92 (VV1+) - Body ground
Always
10 kΩ or higher
D37-2 (VVL-) or D74-91 (VV1-) - Body ground
Always
10 kΩ or higher
D39-1 (VVR+) or D74-87 (VV2+) - Body ground
Always
10 kΩ or higher
D39-2 (VVR-) or D74-88 (VV2-) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
3.
CHECK SENSOR INSTALLATION (VVT SENSOR FOR INTAKE CAMSHAFT)
(a) Check the VVT sensor installation.
OK:
Sensor is installed correctly.
NG
SECURELY REINSTALL SENSOR
4.
CHECK INTAKE CAMSHAFT (TEETH)
Teeth do not have any cracks or deformation.
HINT:
Perform "Inspection After Repair" after replacing the camshaft assembly
.
NG
REPLACE INTAKE CAMSHAFT
3UR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P0340,P0342...
NEXT
5.
REPLACE VVT SENSOR
(a) Replace the VVT sensor
.
6.
CHECK WHETHER DTC OUTPUT RECURS
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Clear DTCs
.
(e) Refer to the confirmation driving pattern.
(f) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
(g) Read DTCs.
Result
DISPLAY (DTC OUTPUT)
PROCEED TO
No output
A
P0340, P0342, P0343, P0345, P0347 or P0348
B
HINT:
If the engine does not start, replace the ECM.
B
REPLACE ECM
A
END
3UR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P0340,P0342...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст