Toyota Tundra (2015 year). Manual — part 1823
(a) Remove the 3 bolts and disconnect the No. 2 water by-pass
pipe sub-assembly.
8. REMOVE NO. 2 ENGINE COVER
9. DISCONNECT FUEL TUBE CLAMP
(a) Disconnect the fuel tube clamp from the bracket.
10. REMOVE NO. 1 ENGINE COVER
11. REMOVE FRONT WATER BY-PASS JOINT
(a) Disconnect the engine coolant temperature sensor connector.
3UR-FE EMISSION CONTROL: AIR SWITCHING VALVE: REMOVA...
(b) Remove the 4 nuts, front water by-pass joint and 2 gaskets.
12. REMOVE NO. 3 WATER BY-PASS PIPE
HINT:
(a) Remove the bolt and No. 3 water by-pass pipe.
13. REMOVE AIR TUBE
(a) Slide the 2 clamps and disconnect the No. 2 air hose and No.
3 air hose.
Text in Illustration
*1
No. 2 Air Hose
*2
No. 3 Air Hose
(b) Disconnect the air pump connector.
(c) Disconnect the air pump connector clamp holder.
(d) Using a clip remover, detach the wire harness claw.
(e) Remove the 2 bolts and air tube.
(f) Disconnect the 2 No. 1 air hoses from the air tube.
14. REMOVE AIR SWITCHING VALVE ASSEMBLY
3UR-FE EMISSION CONTROL: AIR SWITCHING VALVE: REMOVA...
(a) Disconnect the knock sensor connector.
(b) Remove the bolt and bracket.
(c) Disconnect the 2 air switching valve assembly connectors.
(d) Remove the 3 bolts and air switching valve assembly.
15. REMOVE NO. 2 AIR TUBE
(a) Remove the 2 bolts, No. 2 air tube and gasket.
NOTICE:
16. REMOVE NO. 3 AIR TUBE
(a) Remove the 2 bolts, No. 3 air tube and gasket.
NOTICE:
3UR-FE EMISSION CONTROL: AIR SWITCHING VALVE: REMOVA...
Last Modified: 9-16-2014
6.6 G
Doc ID: RM0000030WF02EX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: 3UR-FE EMISSION CONTROL: AIR SWITCHING VALVE: INSPECTION; 2015 MY Tundra [08/2014 - ]
INSPECTION
1. INSPECT AIR SWITCHING VALVE ASSEMBLY
(a) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
1 - 5
20°C (68°F)*
4.5 to 5.5 Ω
1 - Body ground
Always
1 MΩ or higher
5 - Body ground
HINT:
*: Make sure that the air switching valve is at ambient
temperature before measuring the resistance.
NOTICE:
When applying voltage, do not touch terminals 2, 3 and 4.
If the result is not as specified, replace the air switching valve
assembly.
NOTICE:
Make sure the applied pressure is 30 kPa (0.3 kgf/cm
2
, 4.4 psi) or less
If the result is not as specified, replace the air switching valve assembly.
3UR-FE EMISSION CONTROL: AIR SWITCHING VALVE: INSPEC...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст