Toyota Tundra (2015 year). Manual — part 2936
Last Modified: 9-16-2014
6.6 R
Doc ID: RM000002W3C01FX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: HORN: HORN SYSTEM: PARTS LOCATION; 2015 MY Tundra [08/2014 - ]
PARTS LOCATION
ILLUSTRATION
HORN: HORN SYSTEM: PARTS LOCATION; 2015 MY Tundra [08/2...
Last Modified: 9-16-2014
6.6 U
Doc ID: RM000002W3F01JX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: HORN: HORN SYSTEM: SYSTEM DIAGRAM; 2015 MY Tundra [08/2014 - ]
SYSTEM DIAGRAM
HORN: HORN SYSTEM: SYSTEM DIAGRAM; 2015 MY Tundra [08...
Last Modified: 9-16-2014
6.6 T
Doc ID: RM000002W3D01IX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: HORN: HORN SYSTEM: PROBLEM SYMPTOMS TABLE; 2015 MY Tundra [08/2014 - ]
PROBLEM SYMPTOMS TABLE
HINT:
Horn system
SYMPTOM
SUSPECTED AREA
SEE PAGE
Horn does not sound
HORN fuse
-
Low pitched horn assembly
High pitched horn assembly
Integration relay (HORN relay)
Spiral cable sub-assembly
Horn button wire sub-assembly*1
-
Cruise switch wire*2
-
Steering pad switch assembly*3
Horn button assembly
Harness or connector
-
*1: w/o Steering Pad Switch Assembly, w/o Cruise Control System
*2: w/o Steering Pad Switch Assembly, w/ Cruise Control System
*3: w/ Steering Pad Switch Assembly
HORN: HORN SYSTEM: PROBLEM SYMPTOMS TABLE; 2015 MY...
Last Modified: 9-16-2014
6.6 G
Doc ID: RM0000030EL00TX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: HORN: INTEGRATION RELAY: ON-VEHICLE INSPECTION; 2015 MY Tundra [08/2014 - ]
ON-VEHICLE INSPECTION
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the
battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal
notice before proceeding with work
.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
Some systems need to be initialized after the cable is reconnected
.
3. REMOVE INTEGRATION RELAY (UNIT E)
(a) Remove the engine room relay block cover.
(b) Using a screwdriver, detach the 2 claws and disconnect the
integration relay from the engine room relay block.
HINT:
Tape the screwdriver tip before use.
(c) Disconnect the 3 connectors.
4. INSPECT INTEGRATION RELAY (HORN RELAY)
NOTICE:
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст