Toyota Tundra (2015 year). Manual — part 1782
(b) Using a 3-way connector, connect a vacuum gauge to the
actuator hose.
(c) Start the engine.
(d) While the engine is idling, check that the vacuum gauge indicates 0 kPa (0 mmHg, 0 in.Hg) and the rod
is at the OFF position
(e) Fully depress the accelerator pedal quickly. Check that the VSV (for ACIS) turns ON and the rod moves
in the ON direction.
NOTICE:
Make sure to fully depress and release the accelerator pedal within 1 second.
(f) Remove the vacuum gauge, and connect the vacuum hose to the actuator.
(g) Install the V-bank cover.
3. INSPECT INTAKE AIR CONTROL VALVE
(a) Inspect the diaphragm.
If the result is not as specified, replace the intake air
surge tank.
4. CHECK AIR INDUCTION SYSTEM
HINT:
The illustration shows the areas that may draw in secondary air, which could lead to idling problems.
(a) Check that the hoses are installed correctly.
(b) Check for cracks, etc. in the hoses.
3UR-FBE INTAKE: INTAKE SYSTEM: ON-VEHICLE INSPECTION;...
3UR-FBE INTAKE: INTAKE SYSTEM: ON-VEHICLE INSPECTION;...
Last Modified: 9-16-2014
6.6 G
Doc ID: RM0000031GR024X
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: 3UR-FBE INTAKE: VACUUM SWITCHING VALVE (for ACIS): ON-VEHICLE INSPECTION; 2015 MY Tundra
[08/2014 - ]
ON-VEHICLE INSPECTION
1. REMOVE V-BANK COVER SUB-ASSEMBLY
2. INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
(a) Disconnect the vacuum switching valve connector.
(b) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
1 - 2
20°C (68°F)
37 to 44 Ω
1 - Body ground
Always
1 MΩ or higher
2 - Body ground
If the result is not as specified, replace the vacuum switching
valve assembly.
(c) Check the vacuum switching valve operation.
(1) When applying a vacuum to port E, check that air is
sucked into the filter.
If the result is not as specified, replace the vacuum
switching valve assembly.
(2) Apply voltage across the terminals.
(3) When applying a vacuum to port F, check that air is sucked into port E.
3UR-FBE INTAKE: VACUUM SWITCHING VALVE (for ACIS): ON...
If the result is not as specified, replace the vacuum switching valve assembly.
(d) Connect the vacuum switching valve connector.
3. INSTALL V-BANK COVER SUB-ASSEMBLY
3UR-FBE INTAKE: VACUUM SWITCHING VALVE (for ACIS): ON...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст