Toyota Tundra (2015 year). Manual — part 270
Last Modified: 9-16-2014
6.6 J
Doc ID: RM0000028G400SX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: AUTO LSD Indicator Light Remains ON; 2015
MY Tundra [08/2014 - ]
AUTO LSD Indicator Light Remains ON
DESCRIPTION
the AUTO LSD function is activated and the AUTO LSD indicator light illuminates.
WIRING DIAGRAM
INSPECTION PROCEDURE
BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: ...
A
NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration
.
PROCEDURE
1.
INSPECT CAN COMMUNICATION SYSTEM
(a) Check if a CAN communication system DTC is output
.
Result
RESULT
PROCEED TO
DTC is not output
A
DTC is output
B
B
GO TO CAN COMMUNICATION SYSTEM
2.
PERFORM ACTIVE TEST USING TECHSTREAM (AUTO LSD INDICATOR LIGHT)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Select the Active Test mode and operate the AUTO LSD indicator light using the Techstream.
ABS/VSC/TRAC
TESTER DISPLAY
TEST PART
CONTROL RANGE
DIAGNOSTIC NOTE
Auto LSD Indicator Light
AUTO LSD indicator light
ON / OFF
Observe combination meter
(e) Check that the AUTO LSD indicator light turns on and off in the combination meter when using the
Techstream.
OK:
The AUTO LSD indicator light turns on and off in accordance with the Techstream operation.
HINT:
NG
GO TO METER / GAUGE SYSTEM
BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: ...
OK
OK
3.
INSPECT VSC OFF SWITCH
(a) Remove the VSC OFF switch
.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION
SWITCH CONDITION
SPECIFIED CONDITION
6 - 9
Switch is pressed
Below 1 Ω
Switch is not pressed
10 kΩ or higher
NG
REPLACE VSC OFF SWITCH
4.
CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH)
BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: ...
(a) Disconnect the A17 ECU connector.
(b) Disconnect the J22 switch connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
A17-4 (CSW) - J22-9
Always
Below 1 Ω
A17-4 (CSW) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE VSC ACTUATOR ASSEMBLY
BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст