Toyota Camry (2019 year). Instruction — part 11

161

3-2. Opening, closing and locking the doors

3

Op
eration

o

f each

compo

nen
t

CAMRY_U

If the wireless remote control is used to lock the doors when the electronic
key is near the vehicle, there is a possibility that the door may not be
unlocked by the entry function. (Use the wireless remote control to unlock
the doors.)

Touching the door lock sensor while wearing gloves may delay or prevent
lock operation. Remove the gloves and touch the lock sensor again.

When the lock operation is performed using the lock sensor, recognition sig-
nals will be shown up to two consecutive times. After this, no recognition
signals will be given.

*

If the door handle becomes wet while the electronic key is within the effec-
tive range, the door may lock and unlock repeatedly. In this case, follow the
following correction procedures to wash the vehicle:
• Place the electronic key in a location 6 ft. (2 m) or more away from the

vehicle. (Take care to ensure that the key is not stolen.)

• Set the electronic key to battery-saving mode to disable the smart key

system. (

P. 159)

If the electronic key is inside the vehicle and a door handle becomes wet
during a car wash, a message may be shown on the multi-information dis-
play and a buzzer will sound outside the vehicle. To turn off the alarm, lock
all the doors.

The lock sensor may not work properly if it comes into contact with ice,
snow, mud, etc. Clean the lock sensor and attempt to operate it again.

A sudden approach to the effective range or door handle may prevent the
doors from being unlocked. In this case, return the door handle to the origi-
nal position and check that the doors unlock before pulling the door handle
again.

If there is another electronic key in the detection area, it may take slightly
longer to unlock the doors after the door handle is gripped.

Fingernails may scrape against the door during operation of the door han-
dle. Be careful not to injure fingernails or damage the surface of the door.

*

: This setting can be customized at your Toyota dealer.

162

3-2. Opening, closing and locking the doors

CAMRY_U

When the vehicle is not driven for extended periods

To prevent theft of the vehicle, do not leave the electronic key within 6 ft. (2
m) of the vehicle.

The smart key system can be deactivated in advance. (

P. 567)

Setting the electronic key to battery-saving mode helps to reduce key bat-
tery depletion. (

P. 159)

To operate the system properly
Make sure to carry the electronic key when operating the system. Do not get
the electronic key too close to the vehicle when operating the system from the
outside of the vehicle.
Depending on the position and holding condition of the electronic key, the key
may not be detected correctly and the system may not operate properly. (The
alarm may go off accidentally, or the door lock prevention function may not
operate.)

If the smart key system does not operate properly

Locking and unlocking the doors and trunk: Use the mechanical key.
(

P. 526)

Starting the engine:

P. 527

Customization
Some functions can be customized. (

P. 567)

If the smart key system has been deactivated in a customized setting

Locking and unlocking the doors and opening the trunk:
Use the wireless remote control or mechanical key. (

P. 144, 153, 526)

Starting the engine and changing engine switch modes:

P. 527

Stopping the engine:

P. 208

163

3-2. Opening, closing and locking the doors

3

Op
eration

o

f each

compo

nen
t

CAMRY_U

Certification for the smart key system

For vehicles sold in the U.S.A.

164

3-2. Opening, closing and locking the doors

CAMRY_U

For vehicles sold in Canada

165

3-2. Opening, closing and locking the doors

3

Op
eration

o

f each

compo

nen
t

CAMRY_U

WARNING

Caution regarding interference with electronic devices

People with implantable cardiac pacemakers, cardiac resynchronization
therapy-pacemakers or implantable cardioverter defibrillators should keep
away from the smart key system antennas. (

P. 157)

The radio waves may affect the operation of such devices. If necessary,
the entry function can be disabled. Ask your Toyota dealer for details, such
as the frequency of radio waves and timing of the emitted radio waves.
Then, consult your doctor to see if you should disable the entry function.

Users of any electrical medical device other than implantable cardiac
pacemakers, cardiac resynchronization therapy-pacemakers or implant-
able cardioverter defibrillators should consult the manufacturer of the
device for information about its operation under the influence of radio
waves.
Radio waves could have unexpected effects on the operation of such
medical devices.

Ask your Toyota dealer for details for disabling the entry function.

166

CAMRY_U

3-3. Adjusting the seats

Manual seat

Seat position adjustment lever
Seatback angle adjustment
lever
Vertical height adjustment lever

Power seat

Seat position adjustment switch
Seatback angle adjustment
switch
Seat cushion (front) angle
adjustment switch
Vertical

height

adjustment

switch
Lumbar support adjustment
switch (driver’s side only)

Front seats

Adjustment procedure

1

2

3

1

2

3

4

5

167

3-3. Adjusting the seats

3

Op
eration

o

f each

compo

nen
t

CAMRY_U

WARNING

When adjusting the seat position

Take care when adjusting the seat position to ensure that other passen-
gers are not injured by the moving seat.

Do not put your hands under the seat or near the moving parts to avoid
injury.
Fingers or hands may become jammed in the seat mechanism.

Make sure to leave enough space around the feet so they do not get stuck.

Seat adjustment

Be careful that the seat does not hit passengers or luggage.

To reduce the risk of sliding under the lap belt during a collision, do not
recline the seat more than necessary.
If the seat is too reclined, the lap belt may slide past the hips and apply
restraint forces directly to the abdomen, or your neck may contact the
shoulder belt, increasing the risk of death or serious injury in the event of
an accident.
Adjustments should not be made while driving as the seat may unexpect-
edly move and cause the driver to lose control of the vehicle.

Manual seat only: After adjusting the seat, make sure that the seat is
locked in position.

NOTICE

When adjusting a front seat
When adjusting a front seat, make sure that the head restraint does not
contact the headliner. Otherwise, the head restraint and headliner may be
damaged.

168

3-3. Adjusting the seats

CAMRY_U

Pull the seatback lever in the trunk
for the seatback you wish to fold
down and then fold the seatback
down.

Rear seats (folding type)

: If equipped

The seatbacks of the rear seats can be folded down.

Folding down the rear seatbacks

169

3-3. Adjusting the seats

3

Op
eration

o

f each

compo

nen
t

CAMRY_U

WARNING

When folding the seatbacks down
Observe the following precautions. Failure to do so may result in death or
serious injury.

Do not fold the seatbacks down while driving.

Stop the vehicle on level ground, set the parking brake and shift the shift
lever to P.

Do not allow anyone to sit on a folded seatback or in the trunk while driv-
ing.

Do not allow children to enter the trunk.

When returning the seat to its original position

Ensure that the seat belt does not get caught between or behind the seats.

If the seat belt has been released from its guide, pass the seat belt through
its guide. (

P. 30)

Seat adjustment
Be careful not to get hands or feet pinched between the rear console box
and the rear seat when folding down the rear seatback.

After returning the seatback to the upright position
Observe the following precautions. Failure to do so may result in death or
serious injury.

Make sure the seatback is securely locked by pressing it forward and rear-
ward on the top.

Check that the seat belts are not twisted or caught in the seatback.

Make sure that the seat belt is passed through its guide.

NOTICE

When the right seatback is folded down
Make sure the luggage loaded in the enlarged trunk will not damage the
webbing of the rear center seat belt.

170

3-3. Adjusting the seats

CAMRY_U

Adjustable type

Up

Pull the head restraint up.

Down

Push the head restraint down while
pressing the lock release button.

Integrated type

Head restraints cannot be adjusted or removed.

Removing the head restraints

Head restraints

Head restraints are provided for all seats.

Lock release button

1

2

Pull the head restraint up while pressing
the lock release button.
Front seats: If the head restraint touches
the ceiling, making the removal difficult,
change the seat height or angle.
(

P. 166)

Lock
release
button

171

3-3. Adjusting the seats

3

Op
eration

o

f each

compo

nen
t

CAMRY_U

Installing the head restraints

Front seats

Rear seats

Adjusting the height of the head restraints

Align the head restraint with the installa-
tion holes and push it down to the lock
position.
Press and hold the lock release button
when lowering the head restraint.

Align the head restraint with the installa-
tion holes and push it down to the lowest
lock position while pressing the lock
release button.

Make sure that the head restraints are
adjusted so that the center of the head
restraint is closest to the top of your ears.

WARNING

Head restraint precautions
Observe the following precautions regarding the head restraints. Failure to
do so may result in death or serious injury.

Use the head restraints designed for each respective seat.

Adjust the head restraints to the correct position at all times.

After adjusting the head restraints, push down on them and make sure
they are locked in position.

Do not drive with the head restraints removed.
(However, if a head restraint interferes with installation of a child restraint
system, the head restraint can be removed to accommodate the child
restraint system: →P. 54)

Lock release
button

Lock release
button

172

CAMRY_U

3-4. Adjusting the steering wheel and mirrors

Hold the steering wheel and
push the lever down.

Adjust to the ideal position by
moving the steering wheel hori-
zontally and vertically.

After adjustment, pull the lever up
to secure the steering wheel.

To sound the horn, press on or
close to the

mark.

Steering wheel

Adjustment procedure

1

2

Horn

173

3-4. Adjusting the steering wheel and mirrors

3

Op
eration

o

f each

compo

nen
t

CAMRY_U

WARNING

Caution while driving
Do not adjust the steering wheel while driving.
Doing so may cause the driver to mishandle the vehicle and cause an acci-
dent, resulting in death or serious injury.

After adjusting the steering wheel
Make sure that the steering wheel is securely locked.
Otherwise, the steering wheel may move suddenly, possibly causing an
accident, and resulting in death or serious injury. Also, the horn may not
sound if the steering wheel is not securely locked.

174

3-4. Adjusting the steering wheel and mirrors

CAMRY_U

The height of the rear view mirror can be adjusted to suit your driving
posture.
Adjust the height of the rear view
mirror by moving it up and down.

Manual anti-glare inside rear view mirror

Reflected light from the headlights of vehicles behind can be reduced
by operating the lever.

Normal position
Anti-glare position

Inside rear view mirror

The rear view mirror’s position can be adjusted to enable suffi-
cient confirmation of the rear view.

Adjusting the height of rear view mirror

Anti-glare function

1

2

175

3-4. Adjusting the steering wheel and mirrors

3

Op
eration

o

f each

compo

nen
t

CAMRY_U

Auto anti-glare inside rear view mirror

Responding to the level of brightness of the headlights of vehicles
behind, the reflected light is automatically reduced.
Changing automatic anti-glare
function mode
On/off

When the automatic anti-glare
function is in ON mode, the indica-
tor illuminates.
The function will set to ON mode
each time the engine switch is
turned to IGNITION ON mode.
Pressing the button turns the func-
tion to OFF mode. (The indicator
also turns off.)

To prevent sensor error (vehicles with an auto anti-glare inside rear view
mirror)

Indicator

To ensure that the sensors operate prop-
erly, do not touch or cover them.

WARNING

Do not adjust the position of the mirror while driving.
Doing so may lead to mishandling of the vehicle and cause an accident,
resulting in death or serious injury.

176

3-4. Adjusting the steering wheel and mirrors

CAMRY_U

To select a mirror to adjust, turn
the switch.

Left
Right

To adjust the mirror, operate the
switch.

Up
Right
Down
Left

Push the mirror back in the direc-
tion of the vehicle’s rear.

Outside rear view mirrors

Adjustment procedure

1

1

2

2

1

2

3

4

Folding the mirrors

Была ли эта страница вам полезна?
Да!Нет
3 посетителя считают эту страницу полезной.
Большое спасибо!
Ваше мнение очень важно для нас.

Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.

Текст

Политика конфиденциальности