Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 126
ED–2
ENGINE HOOD / DOOR – HOOD
ED
(b) Adjust the cushion rubber so that the heights of the
hood and the fender are equal.
(1) Raise or lower the hood front end by turning the
cushion rubber. Make sure that the clearance is
within the standard range.
HINT:
Raise or lower the cushion rubber by turning it.
(c) Adjust the hood lock.
(1) Disengage the 4 claws and remove the hood
lock release lever protector.
(2) Loosen the 3 bolts.
(3) Adjust the hood lock position so that the striker
can enter it smoothly.
(4) Tighten the 3 bolts after the adjustment.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
B135976
B135978
B135979
B135980
B135979
ENGINE HOOD / DOOR – HOOD
ED–3
ED
(5) Engage the 4 claws and install the hood lock
release lever protector.
B135978
ED–4
ENGINE HOOD / DOOR – HOOD SUPPORT
ED
BODY
ENGINE HOOD / DOOR
HOOD SUPPORT
COMPONENTS
HOOD SUPPORT
CLIP
CLIP
B135984E01
ENGINE HOOD / DOOR – HOOD SUPPORT
ED–5
ED
REMOVAL
HINT:
•
Use the same procedure for both the RH and LH sides.
•
The procedure described below is for the LH side.
1.
REMOVE HOOD SUPPORT
(a) Using a screwdriver with its tip wrapped in
protective tape, remove the 2 stop rings and the
hood support.
NOTICE:
•
Do not touch the rod of the hood support with
gloves, to avoid fibers from adhering.
•
When foreign matter adheres to the rod, it
prevents the rod from moving smoothly and
reduces its holding power.
HINT:
Support the hood by hand while removing the hood
support.
INSTALLATION
1.
INSTALL HOOD SUPPORT
(a) Install the 2 stop rings onto the hood support.
(b) Install the hood support.
B135981
B135982
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст