Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 344
MULTIPLEX COMMUNICATION – MULTIPLEX COMMUNICATION SYSTEM
MP–17
MP
OK
(a) Disconnect the S2 back door ECU connector.
(b) Check the resistance.
Standard resistance
(c) Reconnect the ECU connector.
NG
OK
3
CHECK BACK DOOR ECU (GROUND)
1
8
7
6
5
4
3
2
Wire Harness Side:
Back Door ECU
GND
S2
Front View
B137572E05
Tester Connection
Specified Condition
S2-3 (GND) - Body ground
Below 1
Ω
REPAIR OR REPLACE HARNESS OR
CONNECTOR
REPLACE BACK DOOR ECU
PARK ASSIST / MONITORING – CLEARANCE SONAR SYSTEM
PM–1
PM
CLEARANCE SONAR SYSTEM
PRECAUTION
1.
DISCONNECT AND RECONNECT CABLE OF
NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-)
battery terminal, initialize the following systems after
the cable is reconnected.
(a) Before performing electronic work, disconnect the
cable from the negative (-) battery terminal in order
to prevent it from shorting and burning out.
(b) Before disconnecting and reconnecting the battery
cable, turn the ignition switch OFF and the headlight
dimmer switch OFF. Then loosen the terminal nut
completely. Do not damage the cable or terminal.
(c) When the battery cable is disconnected, the clock
and radio settings and stored DTCs are erased.
Therefore, before disconnecting the battery cable,
make a notes of them.
System Name
See procedure
METER / GAUGE SYSTEM
See page
Negative (-)
Battery Terminal
Cable
D033496E01
PM–2
PARK ASSIST / MONITORING – CLEARANCE SONAR SYSTEM
PM
PARTS LOCATION
NO. 1 ULTRASONIC SENSOR (LH)
NO. 1 ULTRASONIC SENSOR (RH)
CLEARANCE WARNING ECU
CLEARANCE WARNING BUZZER
BACK SONAR SWITCH
ASSEMBLY
MAIN BODY ECU
(DRIVER SIDE J/B)
- IG1 FUSE
IGNITION SWITCH
I102667E01
PARK ASSIST / MONITORING – CLEARANCE SONAR SYSTEM
PM–3
PM
PARK / NEUTRAL POSITION SWITCH
FOR A/T:
BACK-UP LIGHT SWITCH
FOR M/T:
B140771E01
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст