Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 307
LI–120
LIGHTING – REAR DOOR COURTESY SWITCH (for Lower Side)
LI
INSPECTION
1.
INSPECT ACCESS PANEL LOWER LOCK
ASSEMBLY
(a) Check the resistance of the rear door courtesy
switch.
(1) Using an ohmmeter, measure the resistance
between the terminals when the latch is
operated with a screwdriver.
Standard Resistance
If the result is not as specified, replace the
access panel lower lock.
INSTALLATION
1.
INSTALL ACCESS PANEL LOWER LOCK ASSEMBLY
(a) Install the access panel lower lock onto the rear
door.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
(b) Connect the connector, connector clamp and
access panel lock control cable.
2.
INSTALL REAR DOOR TRIM BOARD SUB-
ASSEMBLY (See page
)
3.
INSTALL NO. 1 CUP HOLDER (See page
4.
INSTALL REAR DOOR INSIDE HANDLE SUB-
ASSEMBLY (See page
)
5.
INSTALL LAP BELT OUTER ANCHOR COVER (See
page
)
6.
INSTALL ACCESS PANEL REAR WEATHERSTRIP
(See page
7.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
Open
Half Latch
Full
Latch
E127241E01
Tester Connection
Condition
Specified Condition
1 - 2
Open
Below 1
Ω
1 - 2
Half Latch
Below 1
Ω
1 - 2
Full Latch
10 k
Ω or higher
B135562
B135561
LIGHTING – BACK DOOR COURTESY SWITCH
LI–121
LI
BODY ELECTRICAL
LIGHTING
BACK DOOR COURTESY SWITCH
COMPONENTS
BACK DOOR COURTESY
SWITCH
N*m (kgf*cm, ft*lbf) : Specified torque
7.0 (71, 62 in.*lbf)
E127225E01
LI–122
LIGHTING – BACK DOOR COURTESY SWITCH
LI
REMOVAL
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2.
REMOVE BACK DOOR COURTESY SWITCH
(a) Remove the bolt and back door courtesy switch.
(b) Disconnect the connector.
E127224
LIGHTING – BACK DOOR COURTESY SWITCH
LI–123
LI
INSPECTION
1.
INSPECT BACK DOOR COURTESY SWITCH
(a) Check the resistance.
(1) Using an ohmmeter, measure the resistance
and check the results in accordance with the
value(s) in the table below.
Standard Resistance
If the result is not as specified, replace the back
door courtesy switch.
INSTALLATION
1.
INSTALL BACK DOOR COURTESY SWITCH
(a) Connect the connector.
(b) Install the back door courtesy switch with the bolt.
Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
2.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
Tester Connection
Condition
Specified Condition
1 - Switch body
ON (Shaft not pressed)
Below 1
Ω
1 - Switch body
OFF (Shaft not pressed)
10 k
Ω or higher
E127224
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст