Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 9
1GR-FE EMISSION CONTROL – VENTILATION VALVE
EC–17
EC
ENGINE
1GR-FE EMISSION CONTROL
VENTILATION VALVE
COMPONENTS
VENTILATION HOSE
VENTILATION VALVE
SUB-ASSEMBLY
N*m (kgf*cm, ft*lbf) : Specified torque
27 (275, 20)
A129935E01
EC–18
1GR-FE EMISSION CONTROL – VENTILATION VALVE
EC
REMOVAL
1.
REMOVE VENTILATION VALVE SUB-ASSEMBLY
(a) Disconnect the ventilation hose.
(b) Remove the ventilation valve.
INSPECTION
1.
INSPECT VENTILATION VALVE SUB-ASSEMBLY
(a) Check the operation.
(1) Install a clean hose as shown in the illustration.
(2) Blow air into the cylinder head side and check
that the air passes through freely.
CAUTION:
Do not suck air through the ventilation
valve. Petroleum substances inside the
ventilation valve are harmful.
(3) Blow air into the intake manifold side and check
that the air does not pass through freely.
If the operation is not as specified, replace the
ventilation valve.
INSTALLATION
1.
INSTALL VENTILATION VALVE SUB-ASSEMBLY
(a) Apply adhesive to 2 or 3 threads of the valve.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond
1344 or the equivalent.
G036123E01
G036124E01
Cylinder Head Side
Clean Hose
A137214E03
Intake Manifold Side
Clean Hose
A137215E01
Adhesive
A092670E03
1GR-FE EMISSION CONTROL – VENTILATION VALVE
EC–19
EC
(b) Install the ventilation valve.
Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf)
(c) Connect the ventilation hose.
G036124E01
G036123E01
EC–20
1GR-FE EMISSION CONTROL – AIR FUEL RATIO SENSOR
EC
ENGINE
1GR-FE EMISSION CONTROL
AIR FUEL RATIO SENSOR
COMPONENTS
AIR FUEL RATIO SENSOR
AIR FUEL RATIO SENSOR
N*m (kgf*cm, ft*lbf) : Specified torque
44 (449, 33)
44 (449, 33)
A129979E01
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст