Audi TT (2007 year). Manual — part 49
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Hose clamps for hoses up to 25 mm -3094-
♦ Hose clip pliers -V.A.G 1921-
♦ Drip tray for workshop hoist -VAS 6208-
Removing
– Remove engine cover panel -arrows-.
3. Coolant pipes, coolant temperature senders, coolant circulation pump
187
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Loosen bolt -1-.
– Remove nut -2- and bolt -3-.
– Detach hose retainer -arrow- from fuel filter and move fuel filter
-8- clear to one side with fuel hoses -4 ... 7- connected.
– Release fasteners -1 ... 4- and remove centre noise insulation.
– Release fasteners -arrows- and remove right wheel housing
liner (bottom section).
188
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Place drip tray for workshop hoist -VAS 6208- beneath engine.
– Unplug electrical connector -3- at radiator outlet coolant tem‐
perature sender -G83- .
– Clamp off coolant hoses using hose clamps -3094- , release
hose clips -arrows- and disconnect coolant hoses from coolant
pipe (right-side).
– Remove nut -1- and bolt -2- and take off coolant pipe (right-
side).
Installing
• Tightening torque
Installation is carried out in the reverse order; note the following:
Note
Secure all hose connections with the correct type of hose clips
(same as original equipment) ⇒ Electronic parts catalogue .
– Install right wheel housing liner (bottom section) and noise in‐
.
3. Coolant pipes, coolant temperature senders, coolant circulation pump
189
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4
Radiator and radiator fans
WARNING
Risk of injury as the radiator fans may start up automatically.
♦ Unplug electrical connectors before starting to work in the
area of radiator cowl.
4.1
Radiator and radiator fans - exploded view
1 - Radiator fan -V7-
❑ With radiator fan control
unit -J293-
❑ Removing and installing
2 - Nut
❑ 5 Nm
3 - Radiator cowl
❑ Removing and installing
4 - Coolant hose (top)
❑ Connecting to radiator
5 - O-ring
❑ Renew
6 - Radiator
❑ Removing and installing
❑ If renewed, refill system
with fresh coolant
7 - O-ring
❑ Renew
8 - Coolant hose (bottom)
❑ Connecting to radiator
9 - Bolt
❑ 5 Nm
10 - Nut
❑ 5 Nm
11 - Bolt
❑ 5 Nm
12 - Radiator fan 2 -V177-
❑ Removing and installing
190
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст