Ford Low Cab Forward (Ford year). Manual — part 14

2. Do not wipe off any grease on the battery terminals on the back
surface of the circuit board.

3. Remove the old battery. Note: Please refer to local regulations when
disposing of transmitter batteries.

4. Insert the new battery. Refer to
the diagram inside the remote entry
transmitter for the correct
orientation of the battery. Press the
battery down to ensure that the
battery is fully seated in the battery
housing cavity.

5. Snap the two halves back
together.

Note: Replacement of the battery will not cause the remote transmitter
to become deprogrammed from your vehicle. The remote transmitter
should operate normally after battery replacement.

Replacing lost remote entry transmitters

If you would like to have your remote entry transmitter reprogrammed
because you lost one, or would like to buy additional remote entry
transmitters, take all remote entry transmitters to your authorized
dealer for reprogramming.

Locks and Security

58

SEATING

40/20/40 split bench seat

The driver seat can be adjusted
forward or backward by lifting the
lever (1) located under the seat.
The driver seat back angle can be
adjusted by lifting the lever (2)
located on the side of the seat. The
driver seat back can also be flipped
forward by lifting lever (2). When
pushing the seat back to its upright
position, make sure it latches
securely.

Pull the center seat down while
pulling the loop to flip the seat
down. When pushing the seat back
to its upright position, make sure it
latches securely.

Seating and Safety Restraints

59

Pull the right-hand passenger
seatback down while pulling the
latch handle to flip the seatback
down flat. When pushing the
seatback to its upright position,
make sure it latches securely.

Before returning the
seatback to its original

position, make sure that cargo or
any objects are not trapped
underneath the seatback. After
returning the seatback to its
original position, pull on the
seatback to ensure that it has fully
latched. An unlatched seat may
become dangerous in the event of
a sudden stop or collision.

SAFETY RESTRAINTS

Safety restraints precautions

Always drive and ride with your seatback upright and the lap
belt snug and low across the hips.

To reduce the risk of injury, make sure children sit where they
can be properly restrained.

All occupants of the vehicle, including the driver, should always
properly wear their safety belts.

Never let a passenger hold a child on his or her lap while the
vehicle is moving. The passenger cannot protect the child from

injury in a collision.

Seating and Safety Restraints

60

It is extremely dangerous to ride in a cargo area, inside or
outside of a vehicle. In a collision, people riding in these areas

are more likely to be seriously injured or killed. Do not allow people to
ride in any area of your vehicle that is not equipped with seats and
safety belts. Be sure everyone in your vehicle is in a seat and using a
safety belt properly.

In a rollover crash, an unbelted person is significantly more likely
to die than a person wearing a safety belt.

Each seating position in your vehicle has a specific safety belt
assembly which is made up of one buckle and one tongue that

are designed to be used as a pair. 1) Use the shoulder belt on the
outside shoulder only. Never wear the shoulder belt under the arm.
2) Never swing the safety belt around your neck over the inside
shoulder. 3) Never use a single belt for more than one person.

Combination lap and shoulder belts

1. Insert the belt tongue into the
proper buckle (the buckle closest to
the direction the tongue is coming
from) until you hear a snap and feel
it latch. Make sure the tongue is
securely fastened in the buckle.

Seating and Safety Restraints

61