Ford Low Cab Forward (Ford year). Manual — part 12

WINDSHIELD WIPER/WASHER CONTROLS
• MIST: For a single wipe (without

washer), push the control up
once.

• OFF: Wipers off.
• INT: Interval wiper operation.
• 1: Low-speed wiper operation.
• 2: High-speed wiper operation

: Pull the control toward you to activate washer. Pull and hold for a

longer wash cycle.
Note: Do not operate the washer for more than 10 seconds as damage to
the washer motor may occur.

TILT/TELESCOPE STEERING

Pull the tilt steering control toward
you to move the steering wheel up
or down, or to push/pull the steering
wheel toward/away from you. Push
the control back down fully to lock
the steering wheel in position.

Never adjust the steering wheel when the vehicle is moving.

POWER WINDOWS (IF EQUIPPED)

Do not leave children unattended in the vehicle and do not let
children play with the power windows. They may seriously injure

themselves.

When closing the power windows, you should verify they are free
of obstructions and ensure that children and/or pets are not in

the proximity of the window openings.

Driver Controls

50

Push the switches down to open the windows and pull the switches up
to close the windows.

One-touch down driver’s window

To open the driver window without
holding the control, press the
control marked AUTO completely
down and release quickly. The
driver’s window will open fully. To
stop the window partway down, pull
the control up, then release it.

Window lock (if equipped)

The window lock feature prevents
the power windows from operating
for both driver and passenger.

To prevent power window operation,
press the control down. Press the
control again to restore the window controls.

Driver Controls

51

EXTERIOR MIRRORS

With the doors closed, move the
mirrors to maximize rear viewing
area by adjusting the mirrors left or
right as required.

Adjust the auxiliary convex mirrors.
Convex mirrors are a ball-stud
design for precise adjustment to
maximize viewing area.

The mirror arms can be manually
folded forward or backwards for
narrow spaces like driving through
an automatic car wash or backing
out of a garage with the trailer tow
mirror. The mirrors also can be
folded forward, in front of the
vehicle, to fit within the cab width.

SPEED CONTROL (IF EQUIPPED)

To turn speed control on

If the vehicle is moving, speed
control will be enabled; if the
vehicle is stationary, engine RPM
can be controlled.

Do not use the speed control in heavy traffic or on roads that
are winding, slippery, or unpaved.

Do not shift the gearshift lever into N (Neutral) with the speed
control on.

Driver Controls

52

To turn speed control off

Press CRUISE THRTL or turn off
the ignition.

Once speed control is switched off,
the previously programmed engine
RPM will be erased.

Do not use the speed control in heavy traffic or on roads that
are winding, slippery, or unpaved.

To set a speed

Turn the speed control on.

Press SET COAST. If the vehicle is
moving, this will set the vehicle
speed. If the vehicle is stationary,
this will set the vehicle idle RPM.

If you drive up or down a steep hill, your vehicle speed may vary
momentarily slower or faster than the set speed; this is normal.

Speed control cannot reduce the vehicle speed if it increases above the
set speed on a downhill. If your vehicle speed is faster than the set
speed while driving on a downhill, you may want to shift to the next
lower gear or apply the brakes to reduce your vehicle speed.

If the vehicle speed falls below a predetermined speed or engine RPM
falls below 1,000 RPM, your speed control will disengage; this is normal.
Pressing RESUME ACCEL will re-engage it.

Do not use the speed control in heavy traffic or on roads that
are winding, slippery, or unpaved.

Driver Controls

53