Ford GT (2018 year). Manual — part 13
INFORMATION DISPLAY
CONTROL
E227121
See Information Displays (page 70).
DRIVE MODE CONTROL
E227821
WIPER AND WASHER
CONTROL
E227822
Windshield Washers.
A
Windshield Wipers.
B
See Wipers and Washers (page 57).
LIGHTING CONTROL
E227823
Highbeam control.
A
ADJUSTING THE PEDALS
WARNING
Never use the pedal adjustment
controls when your feet are on the
accelerator or brake pedal when the
vehicle is moving.
E227825
You can find the adjustment strap on the
left side of the center console.
Note: Adjust the pedals only when your
vehicle is in P (Park) and the engine is off.
E227824
Note: The brake and accelerator pedals will
move together during the adjustment
procedure.
1.
Position yourself comfortably in the
seat.
2. Pull the pedal adjustment strap to
release the pedal module. The pedals
will automatically move toward the
drivers feet.
3. Place your foot on the foot rest and
move the pedals to a comfortable
position.
4. Release the adjustment strap to lock
the pedals in position. Reinstall the
strap into the recessed pocket after the
adjustment is complete.
5. Test the application of the brake and
accelerator pedals.
6. If needed perform the pedal
adjustment over until the pedals are at
a distance that is both comfortable and
safe to operate.
WINDSHIELD WIPERS
Note: Fully defrost the windshield before
you switch the windshield wipers on.
Note: If streaks or smears appear on the
windshield, clean the windshield and the
wiper blades. If that does not resolve the
issue, install new wiper blades.
Note: Do not operate the wipers on a dry
windshield. This may scratch the glass,
damage the wiper blades or cause the wiper
motor to burn out. Always use the
windshield washers before wiping a dry
windshield.
Rotate the knob to switch on the
windshield wipers.
E226966
Off.
O
Intermittent - long interval.
I
Intermittent - short interval.
II
Normal wipe.
III
High-speed wipe.
IIII
WINDSHIELD WASHERS
E226967
Note: Do not operate the washers when
the washer reservoir is empty. This may
cause the washer pump to overheat.
Press and hold the button to spray
windshield washer fluid and switch on the
wipers. When you release the button, the
wipers turn on for three additional wipes
and then turn off.
Note: Briefly pressing the washer button
causes a single wipe without washer fluid.
When you use the washers, there is a
courtesy wipe after a short delay to clear
away any drops on the windshield. You can
switch this feature on or off. See
Information Displays (page 70).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст