Ford Windstar (2003 year). Manual — part 18

To adjust the cross-bar position:

1. Loosen the thumbwheel at both
ends of the cross-bar (both
cross-bars are adjustable).

2. Slide cross-bar to the desired
location.

3. Tighten thumbwheel at both ends of the cross-bar.

To remove the cross-bar assembly from the roof rack side rails:

1. Loosen the thumbwheel at both ends of the cross-bar (both cross-bars
are adjustable).

2. Slide cross-bar to the end of the rail.

3. Use a long, flat object in order to depress the tabs on both ends of the
cross-bar.

4. Slide the assemblies off the end.

To reinstall the cross-bar assembly to the roof rack side rails:

1. Slide the cross-bar assemblies over the tabs and into the side rails.

2. Tighten thumbwheel at both ends of the cross-bar.

Driver Controls

74

KEYS

The key operates all locks on your vehicle. In case of loss, replacement
keys are available from your dealer.

You should always carry a second key with you in a safe place in case
you require it in an emergency.

Refer to SecuriLock

娂 Passive Anti-Theft System for more information.

POWER DOOR LOCKS (IF EQUIPPED)

Press control to unlock all doors.

Press control to lock all doors.

Memory lock

If you lock your doors with the power lock switch or the remote
transmitter while the sliding door is open, the door will automatically
lock after it is closed.

Smart locks

With the key in the ignition, in any switch position, and either the
driver’s or passenger’s door open, the doors cannot be locked using the
power door lock switches.

Locks and Security

75

Childproof door locks
• When these locks are set, the

rear sliding doors cannot be
opened from the inside.

• The rear doors can be opened

from the outside when the doors
are unlocked.

The childproof locks are located on
front edge of each sliding door and
must be set separately for each door. Setting the lock for one door will
not automatically set the lock for both doors.
• Move lock control up to engage the childproof lock.
• Move control down to disengage childproof locks.
If your vehicle is equipped with Power Sliding Door(s), refer to the
Power Sliding Door section of this chapter for more information on how
the childproof locks operate with this system.

REMOTE ENTRY SYSTEM

This device complies with part 15 of the FCC rules and with RS-210 of
Industry Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may
cause undesired operation.

Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
• 3–button remote

Locks and Security

76

• 4–button remote

• 5–button remote

The remote entry system allows you to:
• lock or unlock all vehicle doors and liftgate without a key.
• unlock/open a RH power sliding door and/or LH power sliding door (if

equipped).

• activate the personal alarm.
• arm and disarm the perimeter anti-theft system (if equipped).
If there is any potential remote keyless entry problem with your vehicle,
ensure ALL remote entry transmitters are taken to your authorized
dealer to aid in troubleshooting.

Unlocking the doors

1. Press

and release to unlock the driver’s door. Note: The interior

lamps will illuminate and the anti-theft system (if equipped) will disarm.

2. Press

and release again within three seconds to unlock all doors

and the liftgate.

Locks and Security

77