Ford Galaxy / Ford S-MAX. Manual — part 103
Check the ignition switch electrical connector.
2
Is the ignition switch electrical connector clean and
secure?
Yes
GO to A2
.
No
CLEAN and SECURE the ignition switch electrical
connector. TEST the system for normal operation.
A2: CHECK FOR VOLTAGE ON CIRCUIT SBP24A (VT/RD)
Disconnect Ignition Switch C2DC32.
1
Measure the voltage between the ignition switch
C2DC32 Pin 4, circuit SBP24A (VT/RD), harness
side and ground.
2
Is the voltage greater than 10 volts?
Yes
VERIFY the customers concern.
No
REPAIR the circuit SBP24A (VT/RD). TEST the
system for normal operation.
PINPOINT TEST B : NO POWER IN ACC
TEST CONDITIONS
DETAILS/RESULTS/ACTIONS
B1: CHECK FOR VOLTAGE ON CIRCUIT SBP24A (VT/RD)
Disconnect Ignition Switch C2DC32.
1
Measure the voltage between the ignition switch
C2DC32 Pin 4, circuit SBP24A (VT/RD), harness
side and ground.
2
Is the voltage greater than 10 volts?
Yes
REPAIR circuit CDC33A (VT/GN). TEST the system
for normal operation.
No
REPAIR circuit SBP24A (VT/RD). TEST the system
for normal operation.
PINPOINT TEST C : NO POWER IN RUN
TEST CONDITIONS
DETAILS/RESULTS/ACTIONS
C1: CHECK FOR VOLTAGE ON CIRCUIT SBP24A (VT/RD)
Disconnect Ignition Switch C2DC32.
1
Measure the voltage between the ignition switch
CDC32 Pin 4, circuit CDC33A (VT/GN), harness side
and ground.
2
Is the voltage greater than 10 volts?
Yes
REPAIR the circuit CDC32D (BN/YE). TEST the
system for normal operation.
No
REPAIR the circuit SBP24A (VT/RD). TEST the
system for normal operation.
PINPOINT TEST D : NO POWER IN START
TEST CONDITIONS
DETAILS/RESULTS/ACTIONS
D1: CHECK FOR VOLTAGE ON CIRCUIT SBP24A (VT/RD)
Disconnect Ignition Switch CDC32.
1
Measure the voltage between the ignition switch
CDC32 Pin 4, circuit SBP77B (RD/GY) harness side
and ground.
2
Is the voltage greater than 10 volts?
Yes
REPAIR circuit CDC35F (BU/WH). TEST the system
for normal operation.
No
REPAIR circuit SBP24A (VT/RD). TEST the system
for normal operation.
Steering Column Switches - Steering
Column Multifunction Switch LH
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
Installation
1. Disconnect the battery ground cable.
Refer to:
Battery Disconnect and Connect
(414-
01 Battery, Mounting and Cables, General
Procedures).
2.
3.
4.
1. To install, reverse the removal procedure.
Steering Column Switches - Steering
Column Multifunction Switch RH
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
Installation
1. Disconnect the battery ground cable.
Refer to:
Battery Disconnect and Connect
(414-
01 Battery, Mounting and Cables, General
Procedures).
2.
3.
4.
1. To install, reverse the removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст