Ford Galaxy / Ford S-MAX. Manual — part 186
components catch.
Lower the vehicle to take the load off the engine
mountings.
9.
1. Torque: 133 Nm
2.
NOTE: Only tighten the bolts finger
tight at this stage.
10. Torque: 15 Nm
11.
1. Torque: 80 Nm
2.
NOTE: Only tighten the bolts finger
tight at this stage.
12. Remove the assembly stand.
13. Torque: 90 Nm
14. Torque:
1 80 Nm
2 25 Nm
15.
16.
17.
18.
19. Torque: 25 Nm
20.
NOTE: Make sure that a new component is
installed.
21. Special Tool(s):
205-775
22. Special Tool(s):
205-775
23. Torque: 25 Nm
24.
NOTE: Make sure that the exhaust flexible
pipe is not twisted.
Torque:
48 Nm
25.
1.
CAUTION: Jointing compound must
not be used forward of the catalytic
converter.
Torque:
55 Nm
2. Torque: 48 Nm
26. Torque: 48 Nm
27. General Equipment:
Transmission jack
28.
NOTE: Only tighten the bolts finger tight at
this stage.
29.
1. Insert the washer, with inside diameter 22
mm, outside diameter 44 mm and height 5
mm, into the front subframe above the
alignment hole.
2. Insert the alignment pin through the front
subframe alignment holes and the washer.
Special Tool(s):
205-316A
3. Slide the locking plates on top of the
washer and into the groove of the special
tool and tighten the alignment pin sleeve.
30.
WARNING: This step requires the aid of
another technician.
1. Torque:
180 Nm
90°
Stage 1:
Stage 2:
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст