Ford Galaxy / Ford S-MAX. Manual — part 491
Automatic Transmission/Transaxle -
Vehicles With: 6-Speed Automatic
Transaxle - AWF21 - Transmission Fluid
Pan
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Materials
Removal
NOTE: Removal steps in this procedure may contain installation details.
Installation
Name
Specification
Silicone Sealant LB WSS-M4G320-A3 / 6G9N-M4G320-AA
Thread Locking MS WSK-M2G349-A7 / 2U7J-M2G349-AA
1. Refer to:
Air Cleaner
(303-12E Intake Air
Distribution and Filtering - 2.0L Duratorq-TDCi
(85kW/115PS) - DW/2.0L Duratorq-TDCi
(100kW/136PS) - DW/2.0L Duratorq-TDCi
(103kW/140PS) - DW/2.0L Duratorq-TDCi
(118kW/160PS) - DW, Emission Requirements:
Stage IV/Stage V, Removal and Installation).
2. Refer to:
Transmission Fluid Drain and Refill
(307-01 Automatic Transmission/Transaxle -
Vehicles With: 6-Speed Automatic Transaxle -
AWF21, General Procedures).
3. Torque: 25 Nm
4.
CAUTION: Take extra care not to
damage the mating faces.
Slacken the oil pan with a plastic hammer, avoid
distorting the oil pan.
1.
CAUTION: Make sure that the mating
faces are clean and free of foreign material.
Apply sealant to the oil pan.
Material:
Silicone Sealant LB (WSS-M4G320-A3 /
6G9N-M4G320-AA)
2. Material:
Thread Locking MS (WSK-M2G349-A7 /
2U7J-M2G349-AA)
Torque:
13 Nm
3. To install reverse the removal procedure.
Automatic Transmission/Transaxle -
Vehicles With: 6-Speed Automatic
Transaxle - AWF21 - Transmission
Internal Wiring Harness
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to:
Transmission Control Module (TCM)
(307-01 Automatic Transmission/Transaxle -
Vehicles With: 6-Speed Automatic Transaxle -
AWF21, Removal and Installation).
2. Refer to:
Transmission Fluid Pan
(307-01
Automatic Transmission/Transaxle - Vehicles
With: 6-Speed Automatic Transaxle - AWF21,
Removal and Installation).
3.
4.
NOTE: Note the position of the electrical
connectors.
5.
CAUTION: Make sure that the wiring
harness does not catch.
Installation
1.
CAUTION: The component must be
aligned with the installation markings.
1.
NOTE: Make sure that a new
component is installed.
2.
NOTE: Make sure that these components are
installed to the noted removal position.
Torque:
10 Nm
3.
4. To install reverse the removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст